AEG Washing Machines - Page 2 - Popular Questions, Answers, Tips & Manuals

CALL A LOCAL REPAIR SERVICE IT HAS TO BE TESTED TO KNOW WHAT IS WRONG

Depends what the err code states.

you call a local repair service

The cycle timer could be defective or some timer-dependent function is not being performed

the brain is gone

Hi. Replace the watervalve. Its stuck open

Ertor E62

Power relay to heater unit faulty.

Possible fault Heater unit faulty; Wiring faulty; Electronic board faulty.

Machine Status/Action Forced cooling cycle.

Google AEG 14840 washing machine troubleshooting. You will find the answer.

google AEG flio661te gives water safety message for answer.

google AEG washing machine trouble shooting for answer.

google AEG washing machine gives safety massage.

test you water solenoids and replace if faulty

Check motor brushes

This could be the valves not opening all the way that could be due to mineral buildup, check the water pressure in the line and also check to make sure the proper voltage is getting to the valves and if all is ok, replace the valve assembly from any online spares centre.

Power supply problem. Try another plug in. If it still doesnt work you have a wiring problem.

Maybe it helps something https://www.manualslib.com/products/Aeg-Bs-45-3977008.html

To display Error Code:
Move Programme Selector to the Off postion.
Press the 2 buttons on the right and turn the selector 1 position clockwise and hold the 2 buttons for about 5 seconds until all the lights are flashing. Release buttons and turn the selector to the 10th position. The Error Code will be displayed.
Note the code then turn the selector to off ,then on,then off again.

If there is a fault happend the error code should appear on the display (as shown picture below) : There are two types of error code, first one that begins with a letter "C" and a mean customer fault code that can eliminate by the customer. for example: C1 - means "Telescopic runner inside during pyrolyse" Remedy: "Remove side grids during pyrolyse" Faults that begin with letter "F" require the expertise of a service technician especially when it comes to new ovens powered and controlled by electronics. for example: F 239 means: Quantum Touch Controller alarm: 1. If the communication over the bus SPI with the Quantum touch is after 50 trials unsuccessful than alarm is set. The alarm is reset if the communication is okay again. Could be: 1. Connections Board Touch. 2. Board Touch fault. Dado

Maybe heating element is burnt out.

C1 - means that in prewash cycle no water inlet, valve does not open/ interruption or flow rate too low. So I suggest to you following: check water inlet, clean sieve, check inlet valve, check pressure sensor and finally check wiring. Dado