Close all the vehicle doors. Insert the ignition key into the ignition lock cylinder. Press and hold the DOOR unlock switch. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds , the doors will lock and unlock to confirm the programming of that transmitter. Repeat the previous step to program up to four transmitters. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode. Operate the transmitter functions in order to verify correct system operation
I knew the ignition cylinder was the problem for odometer and radio displaybstaying on, so I went ahead and removed it, installed new ignition switch, cylinder and ????
There's your problem .
? 3:49
https://www.youtube.com/watch?v=au-3OSjDXfM
Oct 1, 2013 - Uploaded by OBD Diagnostics
SRS Airbag Fixing - very easy to do the tool is here ... 2004Chevy Silverado service air bag message troubleshoot PART 1 - Duration: 4:09. by ...
ASA 06/2010 ... The airbag light is an indicator lamp on the dashboard to alert the driver (or passengers) to any ... Some vehicles require a special "scanner" or airbagscan tool to reset the light. ... My car was in an accident, the airbag did NOT deploy, but my airbag light is on. What does that mean and how can I fix it?
Sep 15, 2012 - 10 posts - 6 authors
2010 Malibu ltz ... 3 days ago car would not start- dead battery- son jump started it and got it going- now the SERVICE AIR BAG lite is on. ... The dealer with his scan toolholds all the cards when it comes to the air bag system. ... so as soon as I fix the tension sensor, the PPS code will clear and then so will ...
If the seat is not moving forward or backward, but you do hear a click or a motorsound- chances are that you dropped in some change or other debris may be blockling the way. You might also have blown a fuse - look for fuse no. 30, which is a 30 Amp fuse.
Once you've checked all that and if the motor still does not run, then the problem may be with your wiring.
Wire colors between the switch panel and motor are:
• Fore/aft-Tan and Lt Green
• Front up/down-Dark Green and Dark Blue
• Rear up/down-Yellow and Light Blue
• Recline up/down motor's Blue and Light Green
You have to reset the emergency release, here's how:
1. There is a trunk latch mechanisam on the lid; you will see an opening on the bottom of the mechanism - put a screwdriver through it
2. Now pull the emergency handle twice, while the screwdriver is still inside the latch
3. Once done, your emergency release is reset, and your trunk will now function properly.
The cigarette lighter fuse on your 2005 Chevy Malibu Classic is located at the rear end of the car. To access it, pop open the trunk and look for a fuse box on the driver side of the vehicle - it'll be under a carpeted cover. Remove the cover, then the lid of the fuse box, and you will find your lighter fluid in the middle on the bottom row.
The reason you cannot locate a fluid reservoir is because there is none. Your car has an electric power steering. If the problem continues to persist, you may have to replace the power steering pump.