Chevrolet Malibu - Recent Questions, Troubleshooting & Support - Page 4
2014 Ecotec. How to fix service brake assist, service stabilitrak, & ABS indicator light?
First get your braking system checked by a qualified mechanic! The light comes on because the electronics have detected an issue. You might also need to get the vehicle plugged into a diagnostic system or an obd2 scanner to get the Diagnostic Trouble Codes, (DTC's). Get prices at 3 or 4 different garages as prices for diagnostics can be VERY different! Once repairs are done some dash warning light will turn off automatically.
Classic. Why doesn't it start?
It could be either the alternator is not working or the ignition switch is bad or the starter or all three then could be bad. A mechanic could look at your car and see what the problem is.
Rear camber adjustment for leaning? For 05 malibu
To adjust the camber, loosen the inner lower control arm cam-bolt nuts and adjust the cam-bolt to the correct specification. You will need to safely raise the vehicle off the ground to make the adjustment, However you won't get a true reading of camber until the vehicle is back on the ground. I would suggest SMALL adjustments then get BOTH sides checked for the camber alignment.
By twisting the bolts in the lower arm the offset collars on them shift the lower arm in and out to correct the camber.
2005 Chevy Malibu Anti-theft system indicator light
I just had this to happen to me - here's what you do - when it will not crank - turn your key over to ACC and let it stay on here for 15 minutes, the THEFT SYSTEM light will stop flashing. Turn your key back to OFF then turn it over as normal when starting and it will start right back up! Found it out from an auto store! One lady paid over $700 and then found this out!!!
How to change starter on 2006 malibu
Welcome to FixyaRaise the front of the car then slide under the driver's side of the car and locate the starter on the engine
where it meets the bell housing. Unplug the "S" connector from the
terminal on the starter and lay it aside. Remove the nut from the "B"
terminal with a wrench, then remove the battery cable from the starter. Locate the mounting bolts and loosen it. Slide the new starter then tighten the bolts.Please click here if you need further assistance. Thanks If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
Not finding what you are looking for?