Reseting counter after installing new image transfer roller unit

can you explain more the functions of each are as followed fuser melts the toner to the paper so it dosnt rub off ozone filter filters out the ozone so you don't get headaches and turn al the rollers to bubble gum transfer roller pushes the paper onto the transfer belt applying the image to the paper and imagine unit is where thetransfer belt gets the image from

Press "utility/counter" then "details" then stop, 0, 0, stop, 0, 1
This gets you into service mode.
Then press Counter the Life.
Be very careful not to mess with much in the service mode tho.
Good Luck andThank You for using Fixya

I believe the filter is located on the right or left side. The "Transfer Roller Unit" is the foam roller inside the right door.

I would advise having a copier technician replace those items it is not that hard to do but if you dont get the roller seated in the holder properly it can destroy the transfer belt and that could get expensive

In Service Mode -> Counter -> Life -> Select the one you want to reset and press 'C'

hi this unit located in the RIGHT DOOR

you have to clear the counters in tech rep mode.
Utility - counter - details- then the following sequence....

stop-0-0-stop-0-1 then press counter - life - then highlight the parts you changed and press the C button, then exit .

hey.
You have to go to service menu ---> stop -> 0 -> 0 -> stop -> 0 -> 1 ---- and choose counter -> maintance/parts counter find these parts on the list, make them blue/touch them and touch C.
then exit to normal mode

good luck

To reset the life counters for the transfer roller & ozone filter you will need to enter the service mode.

To do this press utilty, meter count,details(if available), then stop, 0, 0, stop , 0, 1.
You should now be in tech rep mode, select counters then life.
Select the transfer roller/ozone filter button and press the C key on the keypad.
It should zero the life count.
Now press end, exit etc until you back at the copy screen.

Warning: Please do not reset or clear any other data within tech rep mode or you may inadvertantly affect the performance of you machine.

Hope this Helps.

You need to go into service mode to reset these parts. Start by hitting the "Utility" button on the control panel. Then select "Meter Count" from the menu. Next hit "Details". Then you need to hit the following buttons in this order, STOP,0,0,STOP,0,1. This will bring you into the service mode on this machine. From there you should select "Counter". From the Counter menu select "Special parts counter". Highlight the parts you replaced and hit the "C" on the control panel to clear the counter. This process should be done for any parts that you replace and will prevent the message from popping up.