Video Game Consoles & Games - Recent Questions, Troubleshooting & Support
Guitar not working properly
Check the D-pad on the guitar. Sometimes it can get stuck slightly and can count for accidental strumming. Also be sure to keep the button pressed firmly when playing chords. It is very sensitive to touch.
2 days ago
Hi.. whenever i try to
Hey there, this is a common error on fifa 11 when trying to run the game from a laptop or even a desktop that doesn't have a graphics card that supports "shader model 3" or better. Your graphics card just doesn't have the requirements to play the game. You can try to update you graphic's card drivers and see if that works and even get the newest version of Direct X and try again, see if that does the trick! good luck!
3 days ago
My PS3 have error code 8002f334
I've seen this error code going around for the older PS3's. From what I can gather, it's a HDD issue that can't be cured easily. Here are the steps to take that I found, that seem to work for all PS3 systems.
- take out the hard drive
- connect hard drive to pc (running windows 7 64bit, but any windows os should work without other software)
- open up disk management - in win7 it asked me to make a master boot record, so I did.
- format in NTSF - that's right, NTSF - don't use quick format
- shut down pc, take out hd, take usb drive too
- put hd back in ps3, put usb stick in ps3
- boot ps3
- a screen will pop-up saying the hard disk have to be formatted
- hold start + Select for 5 sec.
- After formatting the system will restart and the update will start installing
- configure your ps3 setup - done
- Remember to get the latest firmware from SONY onto the USB drive.
3 days ago
No output from power supply
I am assuming that you are very familiar with electronic circuitry and components, use of a DVM and a soldering iron. In the absence of a schematic diagram, and since you have perform initial voltage checks, perhaps you can wing it. Your "brick" will have to follow the basic design of an SMPS (switch mode power supply). Simply stated,an SMPS is an AC to DC to high freq AC then to lo V DC converter. Per your post, you have checked that there is DC (B+) from the AC mains, then what is needed is to check if there is oscillation to produce the high freq AC. Often design calls for an optical coupler, a small rectangular looking component with four pins, two at each end. This is nothing more than a LED and a Light Dependent transistor. Its function is to switch/trigger on the oscillation (and therefore start the SMPS producing the lo B+s).
Again, since there is no readily available schematic diagram, might I suggest that you post back the part numbers of the ICs and transistors. What we can do is pull out their spec/data sheets and/or application diagrams. Such would give us a general idea of the working voltages at what pins and what each component is supposed to do. Example, let us say your power supply uses a 817A/0635 opti coupler and/or an SG5841DZ controller IC, then we can search for them as initially described.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
on Dec 03, 2019
Right analog stick not working
Check the controls on the game's control section. If you play another game that uses the right analog control and it works on that game then it's the control set up for FIFA. Make sure that the analog control light is on when the game boots up. Sometimes if the analog control light is not on when you turn the game on and you turn it on afterwards, the analog stick controls don't work properly. That happened to me on NFS Pro Street. If this helped you leave feedback please. FIXYA!
Sony PS2 Dual...
on Dec 02, 2019
Not finding what you are looking for?