I need a diagram for a v8 2008 chevy impala ss 5.3 engine of a serpentine belt

you did not specify what engine.
google 2009 chevy impala serpentine belt Diagram


copy and paste

https://www.justanswer.com/chevy/3ruw6-need-serpentine-belt-diagram-2006-chevy-3-5-lt.html

https://www.fixya.com/cars/t15630016-diagram_serpentine_belt_2009_impala_3_5l

Question edited for clarity, and correct order of information and toss in a few CAPS where needed.
Question moved to model category.

All Impala are the same, only difference is bore and stroke for the extra capacity.

https://www.google.com/search?q=2008+chevy+impala+3.5+serpentine+belt+diagram

..

open hood on radiator valance

Which engine do you have ?
There should be a diagram on the hood or the radiator support.

Pop the hood of the car and locate the serpentine belt routing diagram. The diagram on the 2003 Chevrolet Impala is on top of the fan shroud. The diagram will be a picture of all of the accessory pulleys and how the serpentine belt is routed among the pulleys. This diagram will give you the exact direction for routing the new belt onto the pulleys. If you cannot find a serpentine belt routing diagram, take a notepad and pen and draw out the exact routing diagram of the old belt across the pulleys.

2 Locate the serpentine belt tensioner. It is located below the alternator on the left front side of the engine. The tensioner on the 3.4 liter, 3.5 liter and the 3.9 liter engines will require a 3/8 ratchet to release the belt tensioner. The 3.8 liter engine will require a ratchet and a 15 mm socket for the belt tensioner. Rotate the belt tensioner clockwise to loosen and remove the belt from the belt tensioner pulley.

3 Slide the old belt from the belt tensioner pulley. Remove the belt from the remaining pulleys and pull the belt from the engine compartment.

4 Route the new belt across the crankshaft pulley first. The crankshaft pulley is the big pulley on the bottom of the engine in the center. Then route the serpentine belt across the remaining pulleys as directed by the serpentine belt routing diagram. Leave the belt tensioner pulley for last.

5 Rotate the belt tensioner clockwise again to relieve the tension and slide the new belt across the top of the belt tensioner pulley. Release the belt tensioner and the belt will tighten up as the tensioner applies pressure to the belt. Make sure the new belt is properly seated in all the pulleys.

6 Crank the engine and inspect the belt again to make sure that it stays seated in the pulleys.

Read more: How to Replace a Serpentine Belt on a 2003 Chevrolet Impala ' eHow.co.uk http://www.ehow.co.uk/how_6120665_replace-belt-2003-chevrolet-impala.html#ixzz1Yi6QLAjb

try this

here you go

No, not even close. I have included belt routing diagrams for both. The first one should be the SS 5.3L which has a lot more pulleys.

Hope this helps. Good luck !

send an email to [email protected] and I will send the diagram to you