20 Most Recent
2010 Chevrolet Impala Questions & Answers
2010 Chevy Impala. Why won't my Chevy Impala move in 1st 2nd 3rd and drive but moves fine in reverse.
Great question.
PRNDL (is the cable good both ends) shifer>?
R good
L good?
Drive , selected and 1st gear car will not move ?
or 1st gear car moves good but will not up-shift.
1,2,3,4 gear. 1st slips or works??????????????
name 4T60 (transverse 4speed box) GM./
DIY?
check fuse first
scan the PCM (the PCM has TCM) the TCM tranny brain and if TCM is not happy it tells you why
so all carsChev 1992+ must be scanned, first.
the 4t60E box is electronic shifted. scan it.
what is miles on car.? 100k,300Kwhat?
causes are vast, (ever see inside any A/T box)
the next test in the book is pump pressure test
PRNDL
2010 Chevrolet Impala ABS issues....
if abs flickered hook up scanner and get code ---new hubs dont mean free from defects or properly installed ---also check the abs connectors for damage or corrosion
Where is the block heater cord on a 2010 chevy impala
It would be about 15 inches in front of the battery, and 18 inches down. You'll see it coiled up along with some other wires, even though its adequately hidden. But if it is not there, look behind the bumper. Otherwise there is a possibility your car did not come with a block heater.
2010 Chevy impala airbag light on, is it a costly problem?
Only if you go to the dealership. I suggest if you own this car and plan on keeping it for a bit get your self Chilton Repair manual and Haynes repair manual. You can at least be familiar with what and how somethings repaired so you could avoid a costly repair. If a mechanic sense you dont know much about cars watch out. These manual have wiring schematics and diagrams indicating where fuses and relas are located. The manuals are vehicle specific so youd ask for Chevy 2010 Chevrolet Impala. Having some knowledge is better than none and no it's not an expensive repair if you are doing it yourself.
Tcs warning light
If a misfire is bad enough the cpu will shut off traction control causing the light to come on. For the engine light to be flashing you need a heavy miss and shouldn't drive it due to potential Cat failure. Changing the coil can fix all issues if that's the only part causing a misfire, typically i would recommend changing the spark plugs while you are in there.
2010 impala no gear indicator no crank no start
The gear indicator is a electonic signal from the PCM / ECM which ever engine computer your vehicle has . A message is sent over the GMLAN serial data network . Do you know what C.A.N. is ? controller area net work . In fact all the thing's on your instrument cluster , speedometer , fuel gauge , temp., ABS , traction control , plus the starting is the samething . The ignition switch is a input to the BCM - body control module . When it see's voltage from ignition switch it sends a message via data bus to the engine computer which in turn will energize the starter relay cranking the engine . There is nothing you can or should do to try and fix this yourself . Your best bet , take it to a qualified repair shop . (dealer ) Because not knowing these systems you can render your vehicle none fixable .
How to Diagnose Controller Area Network CAN
Not finding what you are looking for?
