Texas Instruments TI-83 Plus Calculator Logo
Posted on Dec 07, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Can not get it to start up after putting in all five new batteries. screen is full of wierdness but will turn on/off.

1 Answer

k24674

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Texas Instru... Master 8,093 Answers
  • Posted on Dec 07, 2009
k24674
Texas Instru... Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Aug 17, 2009
Answers
8093
Questions
0
Helped
4675813
Points
21596

Hi,
Where that ''weirdness'' is coming from, I cannot say, but you can press the CLEAR key to clear the screen. Reset the calculator Ram.
Press [2nd][MEM][7:Reset][1:All Ram][2:Reset][ENTER]. Press [CLEAR] to erase the "Ram Cleared" message.

Make it a habit to exit thid-party programs/games after each use. They have a tendancy to get stuck in RAM, thus preventing you from using your calculator.

Hope it helps.
Thank you for rating the solution.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

My vehicle does not start well in the cold..

THERE ARE 2 TEMP SENSORS ONE IS FOR THE LIGHT OR GAUGE AND THE OTHER IS FOR THE ECM. IF THE ONE FOR THE ECM IS FAULTY IT CAN CAUSE HARD COLD STARTS
0helpful
2answers

What are other causes of a phone not turning on besides a dead battery, overheating, and freezing?

replace the battery for starters
check that the charger is putting out the correct voltage
1helpful
1answer

1999 GMC yukon will not start after putting a battery in turns over I think it has something to do with the securty system

The relearn procedure for GM is turn the key on (don't try to start) leave it on for ten minutes, turn it off for five seconds. do this three times, after the third time of turning it off for five seconds try to start it. It is best to have it on a charger as the battery will drain, if it gets down below five volts you have to start over.
0helpful
1answer

Camera turns off by itself after taking a picture

A friend of mine had the same prob after putting in brand new batteries, it was i bit wierd but i tried some different batteries and it started working , try some new batteries. hope this helps.
0helpful
1answer

Car wont start-not a gig

it sounds as if you might have to replace the battery, if your battery is shot you can still get a boost and the car will run because the alternator produces electricity which should take car of the cars functions and top up the charge on the battery. if the battery is no longer taking the charge or not holding it as soon as you shut it off it will not have enough power to start the starter. A lot of automotive place will do a check on your battery if you take it to them.

please note that i'm not a mechanic and this is just based on my own experiance
0helpful
2answers

Phone regularly cutting out

This is due to malfunction of battery,

i have also experienced same kind of problem with nokia set which is other model. i have also done same what you have done. Change or replace your mobile battery. so it 'll finally solves your problem.
0helpful
1answer
0helpful
1answer

Ds Wierdness

Something is most likely wrong with a connection to the top screen. It's going to need to be diagnosed and repaired. Don't waste your time buying a new battery or ac adapter which is a trial solution that alot of people seem to hope will work.
1helpful
2answers

Labtec Wireless Optical Mouse

all i did was keep working with it, like changing the batteries like taking them out and putting them back in....
Not finding what you are looking for?

194 views

Ask a Question

Usually answered in minutes!

Top Texas Instruments Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Jerry Naidoo

Level 2 Expert

152 Answers

Paul Bade

Level 3 Expert

1818 Answers

Are you a Texas Instruments Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...