20 Most Recent Homelite Curved Shaft Trimmer Bump Feed Replacement Line - Page 8 Questions & Answers

Are you continuing to look for kit?

Believe that would be duckbill valve part number 560955001

.030

Remove all fuel from tank and check fuel filter in tank if a lot of trash is found in tank clean tank with carb. Cleaner by spraying and sloshing and pour out and do again until all trash is removed. Then blow out thoroughly with compressed air.

The line closest to the primer bulbs goes very short distance into tank the other line goes to fuel filter in tank.

It would have been from 1965-1983 probably 1982.

Easy things ipfirst remove wire to stop switch.

Parts manual ?

If it only does it after it sets for awhile try leaving fuel cap loose when not in use.

Remove cover that holds fuel and oil tanks in place both will have a duck bill valve in the tank replace them.

Turn H and L adjustment screws all way closed to right counting turns in and writing down. Now turn both 1 1/2 turns out, try to start if starts give full throttle and adj. the H to max speed now adjust L so that it will idle and not hesitate when going from idle to full throttle.

Carburetor probably dirty and possibly metering diaphragm an or fuel diaphragm bad. Would remove carb. Inspect and if diaphgram is busted or very hard would replace.

Do you have model number?

Normally remove the two screws holding the cylinder. Pull cylinder from piston. Then remove the snap rings or springs on one side of piston pin and gently drive out pin with brass rod or hard wood pin.

WHHHHAT

Remove fuel lines at Carb. Blow carburetor cleaner through lines into tank. Spray carb. 1/4 cup carb cleaner into tank shake thoroughly pour out and repeat until clean. Blow out fuel lines into tank with compressed air and blow out tank with compressed air.

Turn H and L jet screws all way to right back each one out 1 1/2 turns. Start and hold full throttle, adj. H for maximum speed then adjust L so it will idle and have very little hesitation when sudden increase of throttle. Once this is done you may have to adj. H a bit more for maximum speed.

[email protected]

Need model number