The PCV valve is located 60 degrees from the driver side. Under the intake manifold coming off the center. Just about a blocks length of distances there is a Z-connector running down the side of the firewall cover. Once you locate the rear motor arm move directly down (horizontally) to the female extender. Open the cover and press lightly with strong mussels on the clamp hoses. Release the rear bumper and jiggle the left arm firmly until the latch reconnects. Disconnect the latch again. The PCV valve should be in plain sight now. It's nearly impossible to local on a rainy day and just as easy when the suns outs puns outs. The Dealership swears the Part # Z-SPARTA1 fits the 2011 models, however, check with your local emissions office to ensure road safety compatibility.
SOURCE: pcv valve
I have a 98 4L SOHC . The valve seems to be behind the intake manifold. The emissions diagram shows 2 hoses going to it. Local dealership swears Part #EV225 is correct. You would not believe how much of the internet is devoted to this situation
SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location
the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.
SOURCE: how do i replace the pcv valve on a 2000 explorer xlt v6 sohc?
On the passenger side of the intake manifold, coming off the bottom
about the center of the engine front to back, you'll feel a hose that
comes off a nipple. That hose makes a 90 degree bend and goes around to
the rear of the motor. Where that hose meets the Y-connector from the
other side of the intake you'll find the PCV valve. It's almost
impossible to see it with the hood installed, and even tougher to reach
it.
A good source of information for Ford Explorers can be found here
SOURCE: PCV valve location
if i know what you are asking, look at where you put your oil in. on the valve cover to the top right should be a plug with a tubeing runs to your air clear tube where the air mass sensor and carb is located. i think that is what you are looking for.
SOURCE: pcv valve :where is it located on a 1999 ford explorer sport 2wd
It is located at the back of the engine near the fire wall. It is gray with a T connector at the top with two hoses coming off of the T and going forward into the intake manifold.
1,353 views
Usually answered in minutes!
×