Question edited for clarity.
Question moved to model category.
83-13 is a communication problem between computers.
83-13: ECM/PCM RELATION FAILURE. 61-23 MODULATOR- CONTROL UNIT POWER SOURCE LOW VOLTAGE.
May 26, 2022
hondaaccordforum.comhttps://www.hondaaccordforum.com > forum > code-...Oct 10, 2015 - The code 71-1 and 71-2 are for the driver's seat position sensor. 71-1 is for an open wire. 71-2 is for a short. The shop manual doesn't give .....
DTC 61-23: ABS Modulator-Control Unit Power Source Low Voltage. Attached is the diagnostic information. My experience has shown a bad battery can cause this code.
Mar 7, 2017
Question edited for clarity.
Question moved to model category.
I don't think I have ever seen quite so much over-use of punctuation :>D
Here are the fuses and relays
https://fuseandrelay.com/honda/accord-9.html
..
This question has come up on Fixya before and the issue was the file format as the poster was trying to upload as a .PNG image.
See page 277 of the Owner's Manual for EX and above trims (or page 255 for LX trims). Below is basically what you need:
Requirements:
JPEG and/or BMP images.
Max dimension per image is 1920 x 936 pixels.
Max file size per image is 2 megabytes.
Importing:
Load up the images on a USB drive.
images must be at the root level of the USB drive.
Connect the USB drive to your USB port.
Select the clock on the touch screen (upper right hand corner), then select Settings.
Follow the menus for importing wallpapers (up to 5 for EX and above, or 255 for LX trims).
JustAnswerhttps://www.justanswer.com > Honda Questions
Mar 31, 2006 - Loosen the locknut and turn the adjuster until the correct dimension is achieved. · Once the measurement is correct, tighten the locknut firmly.
1 answer · Top answer: thank you for the question hope this helps 1990-95 Accord The select cable
..
Hi Ciara Kilgore, are you asking
for us to guess.
or how to do tests that find the 50 causes of dead or stalled engines.
wow a Tee boned car, first one posted like here ever.
amazing post. what are you asking the blind.
D4 lamp (is a huge clue)
what country is this car located or sold to first.
D4 light is like a check engine light for the transmission
it means it is failing.
your forgot to say the D4 lamp is in
the
not told what no start means
1: will not crank , the starter motor is dead.
2: cranks fast the starter motor but the engine fails to start , run and stay running.
D4 shows flash codes on old honda's
when D4 happens, shift the transmission
too all gears and back to park see if engine starts now
2001, we scan the PCM using oBD2 scan tool
all shops know how to do that. ask them to.
on another NOTE
call the guy insurance co. that hit your car
the fix it like new (or total it)
end story. do that now.
D4 is honda magic for DRIVE, the drive lamp flashes when
the tranny fails. and did and crashes to wreck wires. to lots of things. and more.