hondaaccordforum.comhttps://www.hondaaccordforum.com > forum > code-...Oct 10, 2015 - The code 71-1 and 71-2 are for the driver's seat position sensor. 71-1 is for an open wire. 71-2 is for a short. The shop manual doesn't give .....
DTC 61-23: ABS Modulator-Control Unit Power Source Low Voltage. Attached is the diagnostic information. My experience has shown a bad battery can cause this code.
Mar 7, 2017
I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years
I think you could use this manual method instead.. My nephew use it to repair my car and it's totally repaired now. Here's the website he bought it from . reliable-store
hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store
the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there
Want to programs the remote key of your Honda cars, then you must reprogram all of the key-less remotes of your Honda Accord once you are in the programming mode. You must complete each step quickly so to prevent the system from exiting the programming mode.
Note: Maximum Three remote transmitters can be programmed.
Make sure all the doors are UNLOCKED before starting this programming procedure.
1. Turn ignition switch to ON (II)
2. Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed remote can be used for this step.)
3. Turn ignition switch to ACCESSORY (I) or LOCK (O)
4. Turn ignition switch to ON (II)
5. Press the LOCK or UNLOCK button on one of the remotes.
6. Turn ignition switch to ACCESSORY (I) or LOCK (O)
7. Turn ignition switch to ON (II)
8. Press the LOCK or UNLOCK button on one of the remotes.
9. Turn ignition switch to ACCESSORY (I) or LOCK (O)
10. Turn ignition switch to ON (II)
11. Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirm you are in programming mode.
12.Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.
13.Turn the ignition switch to LOCK (O) to exit programming mode.
14. Test remote(s)
For more clarification, i have also shared the video to do this process, Have a look
First, brake pad life depends on your driving style. Drive hard, brake a lot and the pads won't last a long time. Second, the material of the pads can affect life too. It wouldn't hurt to ask the dealership about the service bulletin on your car. If you are a DIY person, you could take it apart and inspect the pads/rotors and scuff them up a bit. I've fixed some minor annoying issues by doing that. Sometimes your pads can get glazed over, and I've had weird little bumps on my rotors that made a horrible grinding noise when coming to a stop. Used my grinder and cleaned/sanded the surface and it hasn't come back in 2 yrs.
If you mean seat won't lock in position. Chance you can fix it but in my opinion get a new seat. I would go to a salvage yard. These seats have a tendency to break I have had several brake on me personally and have seen numerous other that had broken.