20 Most Recent
2000 Honda Accord Questions & Answers
Can't pass 3000 rpm
need to check codes and see if it has oil in it. and go from here.
if the computer sences low oil pressure it sets a rev limiter to try and save the engine. code P1259 i think. 4 or 6 cyl?
Po300 random mulitple misfire detected p1399
If only one of your cylinders was misfiring, you probably would be getting a more specific code than P1399.
Also check the distributor rotor along with the cap and coils and wires (as mrgreenz suggests); the EGR valve to make sure it doesn't leak; your fuel pressure which can cause random misfires if the pressure is too low; and injectors if they are really dirty. If you have really high mileage, I probably would first just change out the plug wires with a new set, then reset the DTC and see if the code comes back.
Hope this is helpful as well.
Codes 12-01, what exactly is?
Error code 12-01: Voltage for VBU (Voltage Back Up).
- Check fuse fuse number 1 (70 Amp), in the under hood fuse/ relay box.
- Check Wiring.
- EPS Control Unit.
Maintenance Light goes on/off/on
When your vehicle is coming up for due maintenance, the light will flash for a few when you start the car. When the time for scheduled maintenance is due, the light will remain on constantly. It's just routine maintenance, but if you haven't done it, that's your reminder. Then, you or your mechanic will have to reset that maintenance reminder light.
My 2000 honda accord japan
the system may just need recalibrating the usul way with electronic power steering is to start the engine the rotate the steering wheel full lock both way a few times to let the pas module to recalibrate itself try it it may work unless the reversed polarity has blown the module or sensors
Not finding what you are looking for?