2003 dodge grand caravan sport the abs light and brake warning light stays on cheked brake, fluids. what may be the problem

Low brake fluid or park pedal slightly applied would be the most common problem. If brake fluid is low, have the brakes checked. It is not a good idea to add brake fluid unless there is a leak as the extra fluid will only spill out when the brakes are replaced.

Check the level of your brake fluid or your brake pads may be worn down and time to have them checked out.

It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

i would start with checking the brake fluid make sure its not low and then if they are full then check your abs sensors at each wheel make sure they are working properly

Check for bad sensors or cracked hub ring

First check brake fluid. If this is ok, one of the ABS sensors are giving a bad reading to the brake force distribution.

Sir,
Your cars problem is of Battery which is needed to be replaced or needs to be recharged if not older then 8 to 10 months.

YOU NEED TO HAVE THE LEARNED FEATURES OF THE INSTRUMENT CLUSTER RESET..NEEDS TO BE DONE WITH A SCANTOOL..IT IS TECHNICAL SERVICE BULLETIN FROM CHRYSLER..RECOMMEND YOUR LOCAL DEALER DO IT

Its fine, but for safe cautions i wouldn't drive until it no longer flashes.

ABS diagnostics requires a scan tool (Chrysler DRB II, DRB III or aftermarket equivalent). the plug is located near the brake pedal. this is the only alternative to get the ABS light off.