...to idler and motor shaft, spring problably popped off idler, or motr shaft reattach and pull idler all the way to right and loop belt around motor shaft and relese(pulley should add tensionto
shaft that holds the idler came out I have a 2002 v star 1100 custom. The shaft that holds the idler gear came out and the gear disengaged from the starter. What holds that shaft in? The starter spins
...idler arm in position then connect spring. Try and hold firmly while you place belt through pulley and fold around motor shaft. If installed right ,the pulley will maintain a constant pressure on the ...
Question about First Edition FEW10P Front Load Washer
pulley groves, not on the shaft on the motor. Witht the idler pull back past the motor. Put the belt by the idler and release the idler gently. The idea is to have the tension of the belt on the idler
...shaft and idler gear you will first have to remove the kick start and brake levers. Then remove the water pump cover and circlip, the impellor, and steel drive pin. Then remove all side cover bolts ...
shaft secure with wrench. Thanks for your assistance. Lift the idler pulley assembly up toward the dryer drum to detach the metal tab on the assembly from the dryer base, and slide the assembly out of
...idler pulley shaft on the motor mounting plate for damage or contamination. 3. Drive pulley. Check the drive pulley for wear, binds or damage to the pulley or pulley shaft. Make sure the pulley turns ...
...directed but must first go around the grooved pulley on the motor shaft. make sure the idler goes on the smooth side of the belt and the grooved side of the belt is in the grooves on the motor
...idler pulley shaft. On my machine, the squeak would go away for a while if I oiled this idler pulley shaft. But it was short lived. Only grease on the idler pulley shaft would silence the squeak. If ...
Question about X646e Laser Printer
...idler pulley and the blade drive shaft pulley and this seems to be why the belts are getting chewed up. I can't quite make out just what is worn or bent to make the idler assembly plate come off at ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions