I have placed photos from my pc to Photoviewer 2.3 but when I try to download photos to Coby DP-152 I just get a download failed message. Why? What am I doing wrong?

Using http://www.google.com and the words coby DP-758 manual

the following manual was located.



https://www.manualslib.com/manual/223658/Coby-Dp-758.html





Coby DP 758 Instruction Manual

See http://www.cobyusa.com/files/setupguide/DP161_SG_161SX.pdf
Which points to http://www.cobyusa.com/?p=prod&prod_num_id=80&pcat_id=3001
Where you can download the Photoviewer software
Looks like the 151 and 161 use the same software.

Hello,

The error you describe, is also mentioned in the Setup Guide for the DP151.
When you connect the Key Chain to the USB port of your computer, on the Key Chain will prompt the message to select: USB charge or USB update.


For proper function of the Chain Key:

0) Before connecting the Chain Key, have the Photo Viewer software installed:
You need adminstrator rights to perform installation of programs.
Install the photo viewer from the CD or download this program
from the Coby support site:
> enter cobyusa.com in the address bar of internet explorer
> enter DP151 in the Product Search bar
now all support for the Chain Key will show
> run the DP151_PhotoViewer zip file directly or save the zip file onto your computer, unzip and run the setup.exe file later

1) Connect the Chain Key and Select USB update on the Chain Key.
Again, to be able to update, you need adminstrator rights.

2) Run the Photo Viewer on the computer.

chyeck for the program in control panel if it is installed then check the installed program in all programs n then configure it using the recommende setting

I found this on an Amazon review. I hope it works for you:

1) Install the software on the CD (although the application won't open just yet)
2) Plug in the usb cable into the pc and the keychain and wait a minute (nothing happened here for me)
3) Unplug the cable that goes into the keychain, and then plug it back in. On the keychain screen, an option menu should come up that allows you to select either to power the keychain or to update the keychain via usb. Select the update option. (Note that drivers might install before this or maybe it found the driver I downloaded at the coby website?)
4) Now that you have selected the update option, you can now open the program that was installed off of the cd. Select the pictures you want, move them over, and then download them to the keychain.

You need to make sure the usb cable is in all the way to the viewer. You have to push it hard. No silver showing. Always need the viewer plugged in first before starting the viewer program. After that it is pretty simple.

Found this on Yahoo.

1. Download the drivers from here: www.mscustomercare.com
2. Make sure the device is fully charged and not in charge mode.
3. Unzip and install the drivers with the device connected to your pc.

Try to see if that fixes the issue

You have to push the USB cable into the keychain until it pops. Push it in hard! I thought mine was all the way in because the keychain lit up, but it wasn't.

download all software and guides from this link
click on downloads to display photoviewer and drivers

ya not comp with vista photo viewer is in xp ed not vista have u tryed the website see if they offer u a driver for vista yet dont use cd is your best bet to sp1 for vista come sout in june then most will work