Cars & Trucks Logo

Related Topics:

Erin Parker Posted on Jan 15, 2019

I have 03 Honda Civic lx what's the torec specs for the valve covers ?

1 Answer

Tom Guadagni

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

  • Contributor 33 Answers
  • Posted on Jan 17, 2019
Tom Guadagni
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

Joined: May 02, 2016
Answers
33
Questions
0
Helped
12910
Points
77

5 Related Answers

Anonymous

  • 319 Answers
  • Posted on Jun 17, 2008

SOURCE: 2003 Honda Civic -LX Timing belt

90000 Miles on the Timing Belt. Do not let this go! A timing belt failure can cause internal engine problems.

Should cost around 200 or so, depending upon your local labor rates.

Good Luck!

Brian

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 01, 2009

SOURCE: Replacing head gasket on 1995 honda civic, require torque specs and secquence

wow. a lot of bad information on this site. Refer to a manual for the proper torque sequence. The civic I believe is a two step torque procedure. First 22 ft lbs, than 53 ft lbs.

Anonymous

  • 141 Answers
  • Posted on Jan 15, 2009

SOURCE: changing oxygen sensor for a 2000 honda civic lx

both are located in the exhaust system. You have to get the car off the ground and follw pipes. You cant miss the O2 sensors.

joyellowhors

  • 303 Answers
  • Posted on Jan 21, 2010

SOURCE: p 1705 code, honda civic lx 2001

Have tranny serviced . Check tranny fluid level fill with HONDA ONLY fluid. If not fixed have fluid drained and filter replaced on tranny

Testimonial: "thanks u very much. the problem has been resolved. very good advice."

Anonymous

  • 162 Answers
  • Posted on Apr 03, 2010

SOURCE: 2003 honda civic how to remove door panel

Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.

Pop out the door handle, and unplug the power lock plug,

Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.

next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)

Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)

Unplug power window connector (big green plug)

Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My car is a 2005 civic dx. i wanted to replace my instrument panel (speedometer, engine temp and fuel guage only) with one ones found in 2005 civic LX and up (with tachometer). if i install this pan

you tell us?
a walk on the wild side?
you could read the FSM on both cars, and figure it out.
not me.... sorry./
but is covered in all civic forums, (never this one)
seen that covered, (lots of issues)
0helpful
1answer

Valve cover torque specs for an 01 honda civic

I have 03 Honda Civic lx what's the torec specs for the head gasket
0helpful
1answer

I need the torque spec for connecting rod bearings on a 2001 honda civic Lx D18ya 1.8L.

I cant find a listing for a Civic 1.8l for 2001. make sure the model/ year and get the engine number from the front pad.
0helpful
1answer

I have a 96 honda civic lx, with 133,300. i just had the exhaust valves replaced,and the guy said the rings were good. it dont smoke, but it is going thru 1 qt of oil every 2 days

if it doesn't smoke then it is throwing the oil out somewhere, probably down at the back of engine at valve cover gasket....he might have screwed up the gasket or tried to re-use th old cork one. but.....check the oil dipstick tube to make sure it is seated properly and not giving you a proper reading....hope this helps
0helpful
1answer

Something in my valve train is ticking, louder when cold or upon start up. It sounds like one colapsed lifter as I can count the clicks.I was told this 2000 honda civic lx dosent have adjustable valves so...

REMOVE THE VALVE COVER AND CHECK THE ROCKER ARMS WITH GAUGE OR JUST TRY TO SHAKE THEM FOR FIGURE IT OUT LOSE ONE. CHECK THE LIFTER SEATS IF ANYTHING BLOCKING THE OIL PASSAGE TO MAKE ITS JOB.IF YOU GONNA REPLACE GET TORQUE SPECS OR IF ANY ADJUSTMENT REQUIRED.
0helpful
3answers

Left Brake light bulb 03 civic lx

This video will show you how to replace the taillight bulb in your 01-05 Honda Civic.


0helpful
1answer

03 Honda Civic LX keyless remotes . . .

THE DEALER SHOULD BE ABLE TO TELL YOU BY THE VIN NUMBER IF THE CAE CAME WITH A FACTORY KEYLESS ENTERY THAN YOU CAN BUY THE REMOTE PAD AND PROGRAM IT
Not finding what you are looking for?

34 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...