Where is the BCM located on a 2008 saturn vue?

SOURCE: 2002 Sayurn vue 3.0L

Under the intake manifold,  it will need to be removed.  Not too hard to do for the average diy but recommend buying a repair manual as a guide.  you will need a 1/4" drive T30 torx socket with a long extension one of the bolts is hidden but the others are under the black cover on the top of the intake.  you will also need to remove the coil pack held on with torx bolts.  8 or 10 inverted torx socket needed for that.

Ronny Bennett Sr.

• 6988 Answers
• Posted on May 11, 2010

SOURCE: I have a error code P0449 on a Saturne vue 2008

Evaporator emissions vent control valve

SOURCE: adding 134a refrigerant to the lower side service

This job requires special tools and special training. If you lack either, you risk SERIOUS personal injury. Injury comes VERY EASILY!

You need to address oil levels, proper and legal refrigerant recovery, system evacuation, and recharge.

You were planning to also replace the receiver/dryer, correct? It also needs the oil in it measured and incorporated into the amount of oil (in %) that would need to be added. FAILURE to address these and other issues will guarantee premature system failure and likely compressor damage.

Take this job to a qualified shop.

Sorry

SOURCE: remote start dont work in 2008 saturn vue and its

The hood latch has a switch in it. The hood latch does not move the entire distance when the hood is closed and the switch does not close so remote start will not work. Everthing else appears to be OK. I have had two hood latch replacements on my 2008.

SOURCE: what is a code p0601

P0601 ENGINE CONTROL MODULE CHECKSUM ERROR

• The nerve center of the fuel injection system is the engine control module (ECM)
• The ECM constantly supervises the information from various sensors, and regulates the systems that start after vehicle performance.
• The ECM is also empowered to control all the diagnostic functions of the system.
• It can detect operational flaws and caution the driver through the Malfunction Indicator Lamp (MIL)
• It also records and stores a Diagnostic Trouble Code (DTC) which detects the likely problem- making parts to help the technician while repairing.
• In order to house the program information and the calibrations required for engine, trans-axle diagnostics operation an electrically erasable programmable read only memory (EEPROM) is used.
• For detecting errors in the software the ECM uses a specially devised value known as the checksum.
• The checksum (self explanatory) is a value that is the sum total of all the numbers in the software added together.
• If the values recorded by the ECM and the checksum do not match then a checksum error is highlighted.