AEG Lavamat W1450 2 years old,

The cycle timer could be defective or some timer-dependent function is not being performed

The E52 code indicates that the motor is not moving. This could mean the the carbon brushes have worn out, the entire motor is bad or that the wiring or control units have damage so that the message to spin is not getting to the motor.

Take off the back of the washer (after unplugging it). Inspect the motor plug and wiring to that plug. If those look okay, take out the motor and inspect the carbon brushes. If those are worn or broken, then you need to replace them. If the brushes are okay, then the entire motor or the control board are more likely to have a fault. See http://shop.aeg.co.uk/search?prpp=20&ppn=1&psfo=A&filter=category%3ALaundry%3AWashing%2BMachines and use the full product number to find out the part numbers you may need. Other sites will have these parts.

I hope this helps. Please add the product number of your AEG Lavamat 74810 if you need assistance finding parts.

Cindy Wells

Lavamat?! Where in the *&%^ is this machine from? Yugoslavia! I'm guessing it will not allow water IN Because only the Spin (Centrifuge) cycle works?! So if that is so you need your water inlet valves replaced, there are Two. Even in machines named after a Bar of Soap!

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

Here is a PDF of the manual for the 808/830 front loader (turned to the Controls page(s):

https://all-guides.com/manual/11655/aeg-lavamat-w-830-user-information-52.html?page=10

Here is another:

https://www.manualslib.com/manual/444440/Aeg-Lavamat-W-808.html?page=10#manual

Good luck.

No fuse inside any home washing machines. As far as I know. Motherboard probably

its not the heat element its the water pump i would say it has gone to ground try disconnecting the water pump if the fuse does not trip then replace the water pump

Waited half hour; on start up F3 had cleared..pump overheat? Suspect sticky pump bearing..new pump.

Sounds like the main drum bearings have failed.
At this age , I don't think this is an economical repair to undertake.
Better to replace with a new one.

I have had the same problem. If you switch the machine to off and then to cotton/linen 95, then press at the same time prewash, soaking, qick wash and stain buttons for 10 seconds switch it off. When I switched it on it worked.

I'm not a technician, but I own a AEG Lavamat. As far as the owner manual says, this washing machine doesn't allow more than 5 kg.