Fuse for rear door locking drivers side - Cars & Trucks

The most likely culprit is a faulty actuator. You can test this by having someone activate the rear hatch while listening for a click or sound of some sort. If there is sound but no opening, it indicates a bad latch actuator. If there is no noise, it could be a fuse or wiring issue. You can manually unlock the door by removing the trim, but be careful around the glass latch as there are 2 push pins.

https://www.autogenius.info/chevrolet-suburban-2006-fuse-box-diagram-2/


Check the wiring in the boot that runs from the body to the top of the liftgate for broken wires.

You might have to take it to a collision shop. Remove the rear hatch panel to gain access to the latch assembly if it's not responding. If you can't get it open, take it to a collision shop as they deal with these kinds of things regularly.

You say the driver window works? wouldn't be a main fuse or fusible link then -driver door locks and window wouldn't work either. Each door has a module inside (computer) . The driver door has a circuit breaker power feed an a fuse DDM fuse 10amp located in rear junction block circuit breaker is located in under hood maxi fuse block. The circuit breaker also feeds battery voltage to the other door modules too. PDM - passenger door module fuse 10amp located in the instrument panel fuse box and the RDM - rear door module RDM fuse 10amp located in the rear fuse box - under the back seat.

Each power window is connected to a permanent magnet motor. The motor raises or lowers the glass when the door module applies voltage to the motor. The direction the motor turns depends on the polarity of the supply voltage provided by the associated door module. The 2 front doors have their own separate modules. The rear seat contains a single module, which controls both of the rear power windows.
A serial digital communications link, called the simple bus interface, is used for communications between door modules and the driver's door power window switches. The use of serial digital communications allows the use of a single wire to convey switching information between the power door lock switch and the driver's door module (DDM). The serial communication is also used in order to transmit switching information from the DDM to the other 2 door modules.
The door modules apply battery voltage of the correct polarity to the respective window motor when any local, or power door lock switch, UP switch is operated, driving the window up. Battery voltage is applied to the respective window motor in the opposite polarity when any local, or power window switch, DOWN switch is operated, driving the window down.

Driver Door Module (DDM)
The driver's door module (DDM) directly controls the driver's door window motor and the express down window feature. The DDM sends window UP/DOWN messages received from the power door lock switch to the passenger door module (PDM) and to the rear door module (RDM) over the simple bus interface (SBI) line. The DDM also contains a class 2 data link which communicates with the other vehicle system modules. The left front power door locks and the outside power mirror are also controlled through the DDM.
Passenger Door Module (PDM)
The passenger door module (PDM) controls the passenger's door window motor. The PDM controls the passenger's door window directly from the right front power window switch or from instructions over the simple bus interface (SBI). The right front power door locks and the outside power mirror are also controlled through this module.
Rear Door Module (RDM)
The rear door module (RDM) controls both of the rear door window motors. The RDM controls the rear windows directly from the rear door window switches or from instructions over the simple bus interface (SBI).

The rear hatch locking is computer contolled .
The BCM also runs diagnostics on the liftgate lock relay control circuit and will set DTC B3825 as current and also send a Class 2 message to the DIC. The DIC will display REPLACE LIFTGATE FUSE to inform the driver that a fault has been detected in the liftgate lock circuit and that the liftgate is not locked. Faults that will set the DTC and cause the DIC to display the message could be any of the following:
• An open ECC fuse
• An open or short to ground in the liftgate lock relay battery positive voltage circuit
• A faulty liftgate lock relay
• An open or short to ground in the liftgate lock relay control circuit
• A short to ground in the liftgate lock actuator lock control circuit
• A faulty BCM

The liftgate lock relay supply and coil sides receive a constant voltage through the battery voltage supply circuit and the ECC fuse. The normally closed contact is connected to ground and the control side is connected to the body control module (BCM). A lock function will occur when a door lock switch activation, keyless entry lock transmission, auto door lock function or a liftgate lock function has been received by the BCM. The BCM will then ground the control side of the liftgate lock relay. This energizes the relay and allows voltage to be applied to the liftgate lock actuator lock control circuit. Since the other side of the liftgate lock actuator is connected to the normally closed contacts of the door unlock relay to ground, the liftgate will lock. When an unlock function occurs the BCM will ground the control side of the unlock relay and the rear doors and liftgate will unlock.
The power door lock system consists of the following components:
• The driver door module (DDM)
• The passenger door module (PDM)
• The body control module (BCM)
• The driver information center (DIC)
• The rear door lock switch
• The door lock relay
• The door unlock relay
• The liftgate lock relay--utility vehicles with liftgate only
• The reversible door lock actuators in each of the doors and liftgate
• LOCKS 20A fuse (rear lock/unlock relay supply voltage)
• ECC 10A fuse (liftgate lock relay supply voltage)

If i were to guess i would say you mite need a new lock actuator , but i don't guess . You could take the hatch inside panel off an check for B+ voltage for the lock actuation as someone pushes the switch . Or have it checked for codes .

From where , any switch ? driver door switch or either passenger door switch . This is a very complex system controlled by modules (microprocessors)
?€¢
The driver door switch assembly (DDSA)

?€¢
The driver door module (DDM)

?€¢
The passenger door module (PDM)

?€¢
The rear door module (RDM)

?€¢
The LH front power door lock switch

?€¢
The RH front power door lock switch

?€¢
The LH front door lock actuator

?€¢
The RH front door lock actuator

?€¢
The LH rear door lock actuator

?€¢
The RH rear door lock actuator

?€¢
The remote control door lock receiver (RCDLR)

?€¢
The power door serial data circuit

?€¢
The class 2 serial data circuit

?€¢
The DRVMDL Fuse - 10 amp

?€¢
The PDM Fuse - 10 amp

?€¢
The RRINMDL Fuse - 10 a
Class 2 and Power Door Serial Data Links
The class 2 and power door data circuits are both serial data links. The serial data circuits replace cables in the vehicle by multiplexing (time-sharing) data to and from each device over a single wire referenced to ground. If the power door serial data is lost, both the rear door module (RDM) and the passenger door module (PDM) enters the sleep mode. With the RDM and the PDM in sleep mode, no power door operations are possible.
Your best bet is to take it to the dealer or an ASE certified repair shop .

There is no reprogramming for the door modules and sorry you dislike the dealer so much ! I work at a GM dealer ,have for over twenty years . No one knows your GM vehicle better . Your messing with something you have no clue about . The dealer is exactly the place you should be taking it to . Do you know the doors all have computers inside ? door modules , and can set DTC'S .Do you know what they are ? diagnostic trouble codes ! Do you know what serial data communications are ?
DTC B1562, B1567, B1572, or B1577
DTC B1582, B1583, B1592, B1593, B1612, B1613, B1622, or B1623
DTC B3142, B3147, B3152, or B3157
DTC B3172, B3177, B3182, B3187, B3192, B3197, B3282, B3287, or B3292
DTC B3377, B3382, B3387, B3392, B3397, B3452, B3457, B3462, B3467, B3472, B3477, B3482, B3517, or B3522
DTC B3527
DTC U1161-U1163 or U1170
The power door lock system consists of the following components:
• Driver door lock switch
• Passenger door lock switch
• Driver door switch assembly (DDSA)
• Driver door module (DDM)
• Passenger door module (PDM)
• Left rear door module (LRDM)
• Right rear door module (RRDM)
• Driver door lock actuator
• Passenger door lock actuator
• Left rear door lock actuator
• Right rear door lock actuator
• Driver door cylinder unlock switch
• Class 2 serial data circuit
• Power door serial data circuit
• DRVMDL Fuse (10 amp)
Driver Door Switch Assembly and Driver Door Module logic, Driver Door Module internal driver operation
• PASS MDL Fuse (10 amp)
Front Passenger Door Module logic and internal driver operation
• RRDR MDL Fuse (10 amp)
Left Rear Door Module and Right Rear Door Module logic and internal driver operation

The first thing to do would be to hook up a factory or professional type scan tool an check for DTC'S - diagnostic trouble code's . This vehicle has very complex electronic's. Serial data communication network,class2 data bus . There are electronic modules inside the door's that control the lock's ,power window's , power mirror's . Your best bet ,take it to a qualified repair shop . Not a fuse problem , driver an passenger door module each have thier own power supply. Two circuit breakers ,PWR/WDO circuit breaker 30 amp. You could check DRVMDL 10amp fuse ,located in the rear fuse box , PASSMDL 10amp fuse rear fuse box , RRDR/MDL 10 amp fuse rear fuse box . Rear fuse box is under the back seat . None of the window's , lock's etc.. work from any door switch ?

Do the power windows work ? DDM - driver door module fuse 15 amp - location is the instrument panel fuse box , plus LT DR circuit breaker 25 amp. Circuit breakers rarely go bad . The power locks are controlled by electronic's .The passenger side has another power supply ,that's why they still work .
Door Lock System Components
The power door lock system consists of the following components:
• The driver door switch (DDS)
• The passenger door switch (PDS)
• The body control module (BCM)
• The driver information center (DIC)
• The rear door lock/unlock relay (LBEC)
• The reversible door lock actuators in each of the doors and liftgate

The front power door lock switches are integral components of the driver door module (DDS) and passenger door module (PDS). The switches are 2 position normally open rocker switches. When placed in either the lock or unlock positions, the switches provide a direct input to the DDS or PDS. The DDS or PDS monitors these inputs and sends a LAN message indicating a change in the switch's respective position. Modules which activate the power door lock motors receive the LAN message and activate the motor in the appropriate direction to lock or unlock the vehicle's doors and liftgate. The rear door lock switch provides a lock and unlock signal to the body control module (BCM). The BCM upon receipt of a lock or unlock signal will control the rear door lock/unlock relay and also send a LAN message to the DDS and PDS to perform the appropriate function.
The modules which activate the power lock motors are:
• The DDS (driver door lock actuator)
• The PDS (passenger front door lock actuator)
• The BCM (both rear door lock actuators and cargo door/liftgate)
The DDS and PDS are directly connected to the respective door lock actuator through the door lock motor lock and unlock circuits. Once a door lock or unlock request has been received, the module will supply battery voltage to one side of the actuator and ground the other causing the doors to lock or unlock.
The rear passenger and endgate doors are controlled by the BCM through the rear door lock/unlock relay which is incorporated onto the printed circuit board in the LH BEC. The BCM controls the unlock relay by providing ground to energize the coil and controls the lock relay by providing battery voltage to energize the relay coil. The energized the relay and allows voltage to be applied to either the door lock motor lock or unlock circuits. Since the other side of the door lock actuator is connected to the normally closed contacts of the opposing relay to ground, the doors lock or unlock.

It's possible you have broken wire or wires inside the flex boot from the body of the vehicle to the driver's door . This happens a lot .
Fuse Block - I/P instrument panel
Left of the I/P behind the side trim panel

Instrument Panel Fuse Block
The instrument panel fuse block access door is
located on the driver side edge of the instrument panel.

Pull off the cover to access the fuse block.

The vehicle may not use all of the fuses shown.

Fuses Usage
1 Rear Seats
2 Rear Accessory Power Outlet
3 Steering Wheel Controls Back light
4 Driver Door Module
5 Dome Lamps, Driver Side Turn Signal
6 Driver Side Turn Signal, Stop lamp
7 Instrument Panel Back Lighting
8 Passenger Side Turn Signal, Stop lamp
9 Passenger Door Module, Driver Unlock
10 Power Door Lock 2 (Unlock Feature)
11 Power Door Lock 2 (Lock Feature)
12 Stop lamps, Centre High Mounted Stop lamp
13 Rear Climate Controls
14 Power Mirror
15 Body Control Module (BCM)
16 Accessory Power Outlets
17 Interior Lamps
18 Power Door Lock 1 (Unlock Feature)
19 Rear Seat Entertainment
20 Ultrasonic Rear Parking Assist, Power Liftgate
21 Power Door Lock 1 (Lock Feature)
22 Driver Information Centre (DIC)
23 Rear Wiper
24 Cooled Seats
25 Driver Seat Module, Remote Key less Entry System
26 Driver Power Door Lock (Unlock Feature)

That doesn't sound like a fuse problem to me. It sounds like you have a bulb out on your blinker or possible bad circuit board in your left rear tail light. The problem with your door locks is most likely a bad door lock motor.

NOTE: Anytime there is a blown fuse - it does no good to replace the fuse until the reason that it blew is corrected.

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.