SOURCE: how do i bypass the clutch starter safety switch for my 99 Metro?
jumper the connector to the clutch safety switch at the top of the clutch pedal lever.
SOURCE: 2000 chevy truck 5.3 liter. air conditioner works
After the clutch disengages ( when it's not suppose to )check the voltage on the + output terminal on the clutch relay, (inside the fuse box under the hood) if you have voltage there, check the voltage at the clutch, if you have voltage there too, its the clutch. The clutch gets worn and will engage when cool,but fails after heat builds up. Check this by tapping the face of the clutch with the ac on, if it's simply a worn clutch it will likely engage for a while.
SOURCE: where is the neutral safety switch located on a
Hi
If you open the hood and look down next to the battery on the left side of the car,,, you will see a round switch with 3 wires on a conector,, this is the switch,, remove the wire plug,,, un screw the switch,, install the new switch,,, plug the wire end in
Let me know if i can help more!
SOURCE: How can I bypass the
just take the connector off and use a big paper clip to connect the 2 terminals inside the connector. Use electrical tape to cover the paper clip and then strap the connector to something so it doesn't flop around. Make sure you remember to push the clutch in before turning the starter or you can damage the starter. Let me know if you have more questions.
SOURCE: how do I bypass clutch
To by pass the switch just disconnect the switch and connect the 2 wires from the switch wiring harness together. If it is only one wire then you connect it to a ground source.
This bypass solution is not recommended in any case. The switch should be replaced for safety measures. It is very inexspensive to buy this switch and is well worth the $30.00. My opinion
4,083 views
Usually answered in minutes!
×