You may need to reset the system.
SEQUENCE ACTIVATED BY THE PARKING BRAKE .
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply the parking brake Once Twice
Note: The system can be set - at time of installation - to require that the parking brake be applied once or twice.
If set for two actuations, pause one second between the two.
4. Remove key from ignition (the system keeps the engine running).
5. Exit the vehicle.
6. Within 60 seconds, close all doors.
7. The system will stop the engine and blink the parking brakes once to confirm the sequence is valid (vehicle is
ready for a remote start command).
SEQUENCE ACTIVATED BY THE REMOTE CONTROL
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply parking brake.
4. Send the start command (Model 801 & 2101 - Model 903 ).
5. Remove key from ignition (the system keeps the engine running).
6. Exit the vehicle.
7. Using the remote, send the STOP command. The system will stop the engine and parking lights will blink once
to confirm that the sequence is valid (vehicle is ready for a remote start command).
http://www.astrostart.com/Support/Guides.aspx
SOURCE: My car was running, then
Hi,
You need to have the cam angle and crankshaft position sensors checked. These are 2 parts which enable the ignition system to fire. If these are ok then check that the rotor in the distributor is turning when you crank the engine.
If it is not turning then you have a cambelt/chain or gear problem which you will need to repair before it will start again.
Hope this helped.
Thanks
Jason
SOURCE: Car won't start. Gages bounce quickly & make a clicking sound on 2006 ford taurus
check your battery,or not clean battery terminals,or starter motor solenoid.
14,192 views
Usually answered in minutes!
×