20 Most Recent 1993 Nissan Pathfinder Questions & Answers

if it blows air only on forth speed then the blower motor resistor is faulty

NO ENGINE TOLD. (nor country)

Question edited for clarity. Question moved to model category. tail lights don't need relays as the amperage is very low. Only headlights and fog lights use relays. https://www.google.com/search?q=1993+Nissan+Pathfinder.+Where+is+the+tail+light+relay Fuse Box diagram https://www.google.com/search?q=1993+nissan+pathfinder+fuse+box+diagram ..

i believe it goes to the alternator

I know this may be a silly Question, so forgive me ...
Did you check the fuses? One fuse controls every thing you listed as being out.
You may also have to make sure your alarm is not interfearing with your diagnosing.
And yes these trucks do have light switch problems. I have often taken the cover off the back of the switch and cleaned the contacts with some fine sand paper.
It works about 4 out of 5 times.
Please let me know if this helps
(:DK

First check your fuse for the fuel pump. if power is on both sides of the fuse when key is on (check with a circuit tester) move onto your fp and pull it and check for power while key is on this ensures power from fuse block is making it to this point. If you have power swap out your fuel pump relay. If you still don't have power at pump then there is a problem in the wiring between relay and pump which you'll need to trace and repair

I dont think they both use the same waring light, check the switch on the handbrake, and make sure its connecting and turning off correctly, could be a bent or broken bracket.

It sounds like the shift cable has either come loose or pulled apart. It's much easier to check with two people. Chock the wheels so it cannot move. Have a friend move the shifter and check that the linkage under the vehicle is moving as the shifter is operated. There are some YouTube videos that can help with diagnosis and replacement

Google the '93 pathfinder, manuals available, & someone may have the same problem. Just google the make & model.

check for l.oose /damaged wires to cam/ crank position sensors

So treating the gas cures the problem? What are you treating it with? If you need further help, I’m available over the phone at https://www.6ya.com/expert/oscar_403cc49e0f00cda7

handle is stripped out go buy one from a junk yard and it has a c clip holding it on ten bucks worth your sanity?

Voltage regulator is shot.