I KEEP GETTING A DE MESSAGE AFTER A FEW MINUTES

copy on my machine then i tray to copy

I dotn have soe USA/Canada numer, but could answer and comment that your "OL" codes, with the tub empty, indicates, that there's a problem in the drive/ tub system or the fill level.
Two choice there, first is that your hub mechanism is sticking. This model floats the basket, and although it does not say so, I am guessing that too heavy a load stops this process. In your case the floating mechanism may be sticking, so the machine thinks it is too heavy a load.

The second possibility is a bad machine control board. In the next link culd find the Repair2000/Library/CABRIOHEWASHER as reference guide to solve it.

Hope helps (remember to rate and comment this answer)..

Hi,

This is a COMMON problem with this handset. There are only few tricks that you could use to resolve this which are mentioned below :-

1. Unplug the unit for few minutes, say 15 minutes and then turn it ON.

2. De-register and re-register the phone.

3. Pull out the battery. Then hold the locate handset button on the base for 4 seconds.The base would beep for around 30 seconds and could resolve the problem.

If the problem persists, you need to send the unit for repair.To be honest, i would afraid to send the unit for repair as the repair cost would be high as compared to cost of the set.Buying a new set would be a much better and wise option.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Kindly check the mesage setting in that there is mesage center no & kindly confirm the same message center & confirm the same with ur telecom service provider customer care hope this will resolve ur issue

you have a blockage try the drain spigot under the sink or the pump may be blocked.

it could be that the magnet in the door lid has slipped or fallen out. I stuck a new magnet on the rim of the machine and the dE eror message went away

Enter service mode by pressing the "additional functions" button, then the "2" and "8" buttons together, then the "additional functions" button again.
You will then go to Copier>Function>Clear and select PWD-CLR. Hit "ok".

Hit the yellow reset button a few times to get back to the regular screen, and you should be able to get into the system settings to change IP config and other settings.

Depending on how it was configured, you may have to restart the machine for the reset to take effect.

Once you change the IP settings, do another restart and wait for about 3 minutes for the machine to get on the network...

Gently remove tank the slide it back in place make sure the back of tank makes good contact with the machine when it is being lowered so that the reed switch can read the magnet in the tank.

I removed the machine from power supply for 30 minutes. then after reconnecting,I ran auto set-up and then in FUNCTIONS,Display,new service to OFF

when I turn the power on screen is blue with "access" message. after a few minutes, message is replaced with "turn power on and off". I have removed and recharged battery but keep getting the same message and other functions of the camera will not work.