Popped LED's into my turn signals and now it won't blink but will turn on/off. Looked all over my bike but can't find it so I can install this Load resistor. @
I actually found my turn signal module in the fairing. I'm waiting for my new one to arrive and hopefully it will fix my left turn signal issue.
Usually under the seat
Here's what they look like:
SOURCE: Where is the oil pan plug located on a 1999 Harley
No oil pan plug, it is a sump system. Just find the oil tank, drain it, change the filter.
SOURCE: 2004 FLHTCUI Electra Glide Ultra Classic: tire pressure for a 2004 ultra classic...
30 psi in the front and 36 in the rear for single rider. Two up riding, raise the rear tire to 40 psi.
Good Luck and Ride Safe
Steve
SOURCE: Need to change neutral light bulb on 1999 electra
You have to remove the outer fairing, there is a small strip of indicator lights the pull out from behind the indicator
First you check that the left turn signal and brake switch wiring haven't been switched. I presume brakes and turn indicators use different bulbs. Then you check for shorted wires from wear or crushing where they go from headlight
2,490 views
Usually answered in minutes!
×