2009 klx 250. The bike won't go into gear, it stays in neutral. Occurred when the bike was warm and running. Thinking problems with shift drum cam. Any ideas or solutions? Is this a major issue? @
1. Yes, this is a major issue! Its not the shift drum cam unless its broken in half. It might be the shift forks, Won't go into any gear? Is there spring pressure in the shifter or does it flop? Is the shifter TIGHT on the shift shaft? I think its time for a professional to look at it.
SOURCE: Clutch slipping while cold, when warm/hot, it operates great.
I have a 2000 Vulcan Nomad FI & had a very similar problem. In fact, it's a very common problem with these bikes. I fixed it by replacing the Clutch Spring. (As Described here: http://www.gadgetjq.com/clutch_spring_replacement.htm
It cost me $40 and 3 hours of time with an impact wrench.
SOURCE: KLX 250 won't fire - new battery
-check the fuse right hand side below the fuel tank and seat, see if it is blown.
- Check to see if plug has spark, replace if necessary .
- Did you run the bike with a low battery before replacing it? could be that your stator is shot.
-Is bike trying to start but won't?
SOURCE: 2004 klx 125l bike ideling
How long has the bike been sitting? The gas may be bad or the carb might need to be cleaned out or choke may be sticking.
SOURCE: 2009 KLX 250 will start and idel, but dies if you
you have a blocked carb jet the engine is running very week to prove this give it a little choke and it should then rev up ok
so you need to strip down the carb and clean out all the jets,,use carb cleaner and dont go poking bits of wire into any jets to try to clear them,,,you will only distroy them that way,,,comprest air would help if you have it if not its carb cleaner
374 views
Usually answered in minutes!
×