Pop your trunk, and you'll see two Torx screws on the side of the tail light assembly. Use your T-15 screwdriver on these.
The tail light assembly should easily slide out at this point. You'll see four connectors: a wiring harness, reverse light, turn signal, and brake light. Disconnect the proper connector, and you'll see the burned-out bulb. Give it a yank, and it will pop right out.
Remove the trim clip center retainer and...
... remove the clip from the trim
Remove the trim from the trunk
Carefully pull back the trim to access the taillamp retaining nuts. Remove the retaining nuts and...
... pull the taillamp away from the body to...
... detach the connectors for the taillamp bulbs and...
... rotate the bulb sockets from the taillamp assembly
Pull the bulb straight out to remove it from the socket
249 views
Usually answered in minutes!
×