It would take someone with a scan tool and some experience to watch O2's to see if the CAT is functioning properly. If you have a code that is pointing to an non efficient CAT check for exhaust leaks before CAT
SOURCE: 1999 Honda Accord Coupe
See an example
DISASSEMBLY
1.
Remove the suction pipe and the O-ring from the oil pump.
2.
Remove the rear cover with the gasket and pins.
3.
Remove the cam ring.
4.
Remove the rotor and vanes.
5.
Remove the front side plate.
6.
Remove the inner and outer O-ring.
7.
Remove the spring.
When assembling, use a new gasket and O-ring.
8.
Remove the pulley nut with the spring washer.
9.
Pull off the pulley and the woodruff key.
10.
Remove the snap ring using snap ring pliers.
11.
Drive out the pulley shaft with the bearing. If necessary, use plastic hammer
SOURCE: 2005 Honda Accord
behind the inside door handle by removing the inner cover you well find two screws remove them by the inside grab handle on the door there is a small rubber mat remove the mat on the upper right corner is a trim piece it just pops off once the screws and trim is removed use a small screw driver and go below the door panel and wedge it between the panel & door and pull back on the screw driver until you here a pop the door panel is held on by plastic clips :caution--when removing the panel DO NOT YANK ON THE DOOR PANEL. THE INSIDE DOOR HANDLE IS STILL ATTACHE D TO THE DOOR PANEL. if you dont unhook this cable before removing door panel you will break the plastic end of the cable if you break this you will have to replace the cable then this well involve removing the latch because the cable is hooked inside the latch hope this helps
SOURCE: SPEED SENSOR LOCATION FOR 1996 HONDA ACCORD
on the trans, its underneath the battery, in-line with the battery clamp toward the front of the car.
SOURCE: 2009 Honda Accord Coupe power outlet problem
yeah you can check your fuses on the driver side under the dash board, you will find one of them blowed.
SOURCE: 1996 honda accord o2 sensor versus Catalytic converter codes p0135 and p0141
The fault code P0135 means O2 Sensor Heater Circuit (Bank 1 Sensor 1)
The code P0141 means O2 Sensor Heater Circuit (Bank 1 Sensor 2)
Launch X431 Connector
83 views
Usually answered in minutes!
×