Question about 2010 Chevrolet Aveo My car is 2010 chev aveo,there is a red dot light by the clock, so my car engine doesn't run

SOURCE: 2008 Chevrolet Aveo Car Radio

remove the trim around the radio. that goes down to the cup holders. take it out by removing the screws. and wires

SOURCE: what torque spec for chev aveo 2004 cylinder head

18 lb ft+60°+60°+60°+10°

NEW HEAD BOLTS ARE REQUIRED WHEN REPLACING THE HEAD OR HEAD GASKET.

SOURCE: 2004 Chevrolet Aveo Brake lights not working

A couple of days ago my brake lights on my 2004 Chevy Aveo wouldn't work, so I attempted to remove the lamp covers to check the bulbs. Also, before this my shifter would get stuck in park and could only be released by pressing the unlock gadget next to the shifter. Back to the brakes...Well, you open the trunk and remove the two screws just like the manual said, but it was very hard to pull off. There's 2 prongs holding the other half of the light on. The lamp will come loose by prying it (very hard). You think the cover will break, but it'll come loose. The bulbs were all OK.

After much frustration and internet info, the STOP LAMP SWITCH, GM#96436331 ($9.30 at Chevy dealer), which is located under the dash and has contact with the brake pedal, was defective. Once replaced, both my brake lights AND SHIFTING problems were cured. So if the brake lights suddenly don't work or you have problems getting the vehicle out of park, check the switch by pushing the prong (end that has contact with brake) of the switch in and out. If it doesn't retract smoothly...that's the PROBLEM. Good Luck.

SOURCE: remove a cd player from a Chevrolet Aveo

on the 08 aveo you simply remove the trim pieces on the left and right of the cd player there you will find 2 mounting screws per side undo cd player slides rate out i replaced mine with 2 din touch screen dvd w\ gps 2 10 inch subs 1000watt amp in band pass audio box and 600 watt amp and 2 5 1\2 inch lanzars lotta boon im my vroom vroom

SOURCE: The HOLD LIGHT CAME ON AND CHECK ENGINE LIGHT CAME

There is a hold button on the shifter or the console. When activated the transmission is locked into the selected gear and the hold light will come on.

An example is putting the transmission in 4th gear, pushing the hold button, and taking off in the snow. Wheel slip would be limited.

You will need the check engine light code read with a scanner and diagnosed.