Chevrolet Cars & Trucks - Recent Questions, Troubleshooting & Support


from what i found out by going on line top speed is 80 to 90 mph.if it is a 6cyl.motor 235 cb in.

Chevrolet Cars &... | Answered 1 hour ago


in relation to the cruise control ????? There is no vacuum used for cruise control on your vehicle . Your vehicle has a computer controlled electronic throttle system .The powertrain control module (PCM) monitors the signal circuits of the cruise control switches in order to determine when to capture and maintain the selected vehicle speed. The PCM uses the throttle actuator control (TAC) module motor in order to control the vehicle speed. For further information on the TAC system, refer to Throttle Actuator Control (TAC) System Description . Your best bet , take it to a qualified repair shop. Need a factory or some other professional type scanner to check for codes an data input from the switches to the PCM

2005 Chevrolet... | Answered 7 hours ago


The ignition switch should be located at the lower part of the steering column and is actuated by the key cylinder. It is difficult to replace (made hard for thieves to get at it).

2006 Chevrolet... | Answered 9 hours ago


usually just need to pull the fuse or relay out , if you want to check the wiring to the fuse box then i would expect will have to remove all fuses to gain acsess, disconnect the battery first

2007 Chevrolet... | Answered 12 hours ago


there is a possibility that it could cause numerous issues, including shifting and braking problems(w/ABS). The vehicle is doing adaptive strategy each time you reconnect and drive. Vehicles have to go thru 3 drive cycles, and this doesn't mean 3 trips to the store and back, to readjust after memory is lost from battery interruption.

1998 Chevrolet... | Answered 14 hours ago


WHAT ENGINE DO YOU HAVE IN YOUR CAR?

1997 Chevrolet... | Answered Yesterday


There are 16 possible codes: 1156, 1165, 1251. 2145, 2152, 3241, 3346, 3351, 3451, 4316, 4362, 4313, 4524, 5241, 5624, 6361

2004 Chevrolet... | Answered Yesterday


PULL THE WHITE OR CLEAR CONNECTOR AT THE PCM,,,CHECK THE WIRE AT PIN 18 (BLACK WIRE / WHITE STRIPE FOR GROUND.
The following is a summary of the instructions included with the service kit:
1. Remove the negative terminal from the battery.
2. Move the wire located at connector J3 (WHITE/GREY/CLEAR), pin 18 to connector J1 (BLUE), pin 23.
3. Install the jumper wire between connector J2 (RED), pin 26 and connector J3 (WHITE/GREY/CLEAR), pin 18.
4. Install the tag included in the kit around the VCM wiring harness. This tag notes that the wiring harness has been modified.
5. Reconnect the negative battery terminal.

Road test to verify that the condition has been corrected. If any of the following conditions are noted, the transmission should be repaired or replaced using the most cost effective method. Canadian dealers should repair the transmission.
1. Transmission fluid oxidation or excessive sediment.
2. Transmission slip or flare after this service fix is performed.
3. DTC P1870 is stored on a 4L60-E (M30).

The following tools are available from Kent-Moore (1-800-345-2233) for use in removing and relocating the VCM wires:
1. J 41758 Terminal Tool; used to remove the wire from the VCM connector.
2. J 41759 Punch; used to punch a new hole through the connector seal

Chevrolet Camaro... | Answered Yesterday


CHECK FOR BAD SENDER OR BROKEN OR MISSING WIRE.
DO A MANUAL OIL PRESSURE TEST TO MAKE SURE YOU HAVE ADEQUATE OIL PRESSURE.

Chevrolet Camaro... | Answered Yesterday


YES,,, FIND THE POWER LEAD TO THE BACK UP ALARM AND INSTALL A SMALL RESISTOR IN THE WIRE. OR FIND THE FUSE IN THE FUSE BOX AND INSTALL A VARIABLE RESISTOR IN PLACE OF THE FUSE. MAKING SURE THAT IS THE ONLY THING CONTROLLED BY THAT FUSE.

2013 Chevrolet... | Answered Yesterday


Disconnect battery first
lift up the truck
Drain transmission liquid
use transmission lifter to raise and lower transmission
unscrew bolts connecting transmission to engine
unscrew bolts connecting transmission to the back of your truck
unscrew bolts connecting transmission to the frame
will come freely. Be careful

2002 Chevrolet... | Answered Yesterday


Liftgate control moduel uses sensor inputs to control the it , maybe one of these sensors is bad . Having a qualified repair shop hook up a professional type scan tool an check for DTC'S - diagnostic trouble codes in the lift gate control module would be the first place to start

2015 Chevrolet... | Answered Yesterday


hi,
sounds like you have a security problem have it checked by a shop. you could disconnect the battery and see if that works.

2009 Chevrolet... | Answered 2 days ago

Not finding what you are looking for?
Chevrolet Logo

212,755 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...