Remove key from ignition switch.
Close all doors.
Open drivers door
Insert key and turn to ON position and within 10 seconds turn key off and remove key.
Within 20 seconds Close and open drivers door 3 times.
Insert key and turn to ON position and within 10 seconds turn key off and remove key.
Locks should now lock and unlock automatically to confirm you have entered programming mode.
Press the UNLOCK button on remote and locks should cycle to confirm programming.
Repeat step 8 on each additional remote.
Exit vehicle with keys and remote, close door test remote(s).
And I personally suggest you find a professional key fob installer in your area. he will help you properly
Thaks
SOURCE: suzuki grand vitara 2.0 TDI
This could the problem with onboard computer failure .......
try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires...
Please mention make code and year of the peugeot engine in the car.....
Good luck....
SOURCE: where is the starter for a 2000 suzuki grand vitara located
starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch
SOURCE: central locking fob
Programming
When
Remote control buttons operated repeatedly while vehicle out of range and system becomes inoperative. System malfunction.
How
Ensure ignition switched OFF and all doors closed. Proceed as follows: Within 10 seconds, open driver's door and switch ignition ON. Within 10 seconds of switching ignition ON, switch ignition OFF. Within 20 seconds of switching ignition OFF, press and release driver's door contact switch 3 times. Within 10 seconds of releasing driver's door contact switch, switch ignition ON then OFF. Within 20 seconds of switching ignition OFF, press and hold both remote control buttons in turn for at least 5 seconds. The driver's door should lock and unlock once. Within 5 seconds of driver's door locking/unlocking, press remote control lock button Fig. 1 [1] or unlock button [2]. Programming procedure complete. Confirm programming has been successful by locking and unlocking vehicle.
NOTE: A maximum of 2 remote controls can be programmed.
SOURCE: How to change the fuel filter on a suzuki grand Vitara
Fuel FIlter - Removal
To install:
Negative battery cable
Fuel lines from the fuel filter
Fuel filter
Fuel filter and tighten the bracket bolt. Note the fuel flow
directional arrow.
Fuel lines to the fuel filter.
Negative battery cable
To install:
Negative battery cable
Fuel lines from the fuel filter
Fuel filter
Fuel filter is incorporated in fuel pump assembly in fuel tank.
Fuel filter and tighten the bracket bolt. Note the fuel flow
directional arrow.
Fuel lines to the fuel filter.
Negative battery cable
Hope this help.
SOURCE: Is it possible to program
try this...
1. Make sure vehicle is in Park
2. Press Vehicle Information button (has the icon of a car and an 'i')until 'PRESS *check mark* TO RELEARN REMOTE KEY' displays.
3. Press set/reset button. The message 'REMOTE KEY LEARNING ACTIVE' will display.
4. Press and hold the lock and unlock buttons on the transmitter at the same time for about 15 seconds. A beep will sound indicating that the transmitter is matched.
5. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of four transmitters matched to it.
6. To exit the program mode, you must cycle the key to LOCK.
If that doesnt work, go to: http://www.bing.com/search?q=how+to+program+a+keyless+entry+fob+for+a+2002+Suzuki+Grand+Vitara&go=&form=QBLH&qs=n&sk=
755 views
Usually answered in minutes!
×