Pull the starter and check the teeth on eng flywheel
It might not be lining up with the flywheel correctly
SOURCE: 2002 Chevy Trailblazer Engine Codes
This is actually an easy swap out. Remove the electrical connection, remove the retaining bolt and pull out old one. I believe the sensor is located in the front passenger side of the engine on this particular model.
SOURCE: license plate light replacement
The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.
SOURCE: where is starter located on
it is on the passenger side
un hook the battery
jack the truck and block it
climb under the truck and you will see it sticking in the trany from the motor
remove the two 5/8 bolts and the starter its round don't loose the shims you
will need them when installing the new one
once the starter is hanging you need to remove the battery wire and depending
on the starter some have 2 little wires others have 1 once all the wires are
disconnected you can now match your old one with the new one.
put back in reverse the steps reinstalling the new one
hope this helps you
bob
SOURCE: starter on 2004 chevy trailblazer
When my battery goes dead and the key is in the acc postion then i cant get the key out
233 views
Usually answered in minutes!
×