Sears Washing Machines - Page 2 - Recent Questions, Troubleshooting & Support

Some machines used a variable speed slow down process to avoid clothing damage, this removes the items from the outside of the drum where if the clothing was left for a length of time after the cycle has finished it could damage the fibres, this way the clothing is also easier to remove from the machine and promotes airflow over the items

F2 mean that you have a drainage problem and could be that the pump is clogged. I believe the pump can be accessed from the front of the washer. Also make sure electrical connections are secure. Make sure no hoses are clogged or kinked anywhere.

your pump may be clogged or there is a clog between the tub and ejection hoses.

Or the washer is one piece and it lifts entirely as a shell off the base.

Or your water level switch need replacing based on your information.

Look on the side with the burners for a connector with two wires coming out and going to control unit.

Might be the hose from tub to pump or pump to outside. Check each by raising the unit and do a spin cycle.

have a second person help u do this test....one holds the door button in and turns the drum in the direction it goes while the second person hits the start button...if u can manually turn drum and it takes off and goes,its prolly a bad motor,start windings are not engaging or the motor switch is stuck....only other cause would be the timer/control board,that needs a vom to ck for power for the start...good luck!!!

The "IE" error code indicates that there is a water inlet problem on an LG washing machine. This code appear's if the washer will not fill to the correct water level. There are 3 possible causes for the IE code. 1) partially or fully closed water supply lines 2) improperly attached supply hoses 3) clogged supply hose filters (on machine and in the hoses).

washer door lock YouTube dryer door lock YouTube

Kenmore Elite HE3T DLF or Error Code Fix Washer Front Load Sears Kenmore Elite oasis dryer error YouTube

have you put some water in the lint box. you need to change the water after every use as well

have you cleaned the filter if its two or three years old also check the motor brushes

AS YOU SHOULD KNOW KENMORE APPLIANCES MADE BY MANY DIFFERNT COMPANIES AND WITHOUT FULL MODELL NUMBER IT IS HARD TO SAY WHAT IS PROBLEM BUT COULD BE DOOR LOCK OR MAIN CONTROLL BOARD PROBLEM

shocker broken in side replace connects to side of drum replace it

Remove the top pannel shud b two screws at the back then slide top of to get acess

That means that it has been overloaded. IF it is giving this error and there is nothing in the machine then it has a bad sensor. It could also be that the drum has broken loose from the shocks or springs that support it.