Kenmore Elite - Recent Questions, Troubleshooting & Support - Page 2
We are getting an error code of F 35
Hi
Error
code F 35 means ANALOG PRESSURE SENSOR FAILURE. There is any malfunction of the
component detected by the Steamer Electronic Board. Please check whether the
pressure hose is fixed firmly, and the air trap is not blocked. Make sure the
hose is not plugged. If this doesn't resolve the issue then it is a problem
with the water level pressure switch operation. There could be a blockage in
the air dome or pressure switch hose. The air dome is located on the back of
the tub on the left hand side. If the pressure switch hose and the air dome is
clear of any blockages, then there is an issue with the water level pressure
switch, you would need to replace it. Hope
this helps...please post back for further assistance.
Daniel
Machine will not switch to drain and spin cycle
If you take the front off in the lower right you will find a pump motor that controls the drain flow. This may defective. Use a shop vac to empty the water in washer if needs be. But remove and test this pump.
Kenmore Elite HE4t Washer door won't lock
If your washing machine is still under the manufacturers warranty I don't believe Sears should be charging you anything for the call. But, if you wish to steer clear of that mess and repair the washer yourself, I can give you some advice. The problem is your door latch assembly. The "Fdl" displayed is a failed door latch error code. If it is occurring intermittently right now, you are simply going to buy some time before it eventually goes bad. When it does, the washer will not run. The part number is 1094190 and costs about $50. Just to be sure, post back with comments as to your model number (located along the door frame opening) and I will research to ensure the part number is correct. The latch assemblies have not changed over recent years and are interchangeable between model numbers. If you still wish to repair yourself, I can also give you step-by-step instructions. It is not a difficult repair, but it is a little tedious. Let me know. I hope this helps you.
I make homemade liquid laundry saop and when I use
you NEED to buy real washing soap from a store. I recommend Tide because you may be mixing wrong ingredients or not adding something. If buying new/real soap doesnt work i would go to a sears or email sears at their website and tell them.
Kenmore elite 5t steam f35 and sud problem
The
F35 error code indicates a problem with the analog pressure sensor, air
hose or air trap. If the hose and trap are good you will need to
replace the pressure sensorThe "Sud" error code indicates too
much or the wrong kind of laundry soap was used. Be sure to use only HE
(high efficiency) detergent on this model of washer.Please see the links provided below for access instructions & other troubleshooting tips covering the error codes displayed:- Link 1- Link 2Hope this helps (remember to rate this free answer and leave some testimonial).
Clothes have a musty smell if left in the washer
Make shure to do a cleaning cycle. As well, wipe out the inside, the rubber gasket and the door when done washing for the day. We also have found that
leaving the door "Open" for several hours, when finnished, eliminates any future
smells.
Our kenmore elite quiet pack
Always start with the simplest thing, verify that the outlet is good before troubleshooting the machine. I cannot tell you how often the home electrical is the problem not the machine.
Not finding what you are looking for?