Electrical Supplies - Page 8 - Recent Questions, Troubleshooting & Support

Question edited for clarity. Question moved from Motorcycles to Generators. No wiring diagrams. but there are Parts. Normally when you turn these units and motorcycles off, you are just dumping the coil spark to ground. Look for grounds that aren't good. Another possibility is that if the cylinder head is coked up with carbon and it carries on igniting the fuel / air mixture. https://www.google.com/search?q=suntom+6.5+gf-lge+wiring+diagram ..

FAULT NAME: VMN HIGH - FAULT DESCRIPTION: wrong voltage on power motor outputs, failure in the power section or in the mosfet driver circuit or in the motor. https://www.forkliftaction.com/forum/trouble-code-31.aspx?t=14834 https://errors-codes.jimdofree.com/clark/

Technically, NO. Using Romex cable inside a buried conduit is NOT ACCEPTABLE as a buried conduit is considered a damp location due to the potential for water condensation inside the conduit and Romex is not rated for wet or damp locations. To meet code requirement for conductors inside a conduit you'll need to meet 3 major requirements 1. All conductor insulation must be rated to the highest voltage of any circuit inside the conduit. 2. A buried conduit is a damp location. 3. Conduit capacity restrictions.

Question edited for clarity 'Devilish' to DeVilbiss GB5000 Type 2 Generator. You just unbolt the pull starter assembly from the side of the engine. There is a clutch type unit that grips the crankshaft. https://www.google.com/search?q=devilish+gb5000+generator+parts

Question edited for clarity.Schumacher have great customer support. Wiring diagrams are usually in the manuals but not this model.https://www.jegs.com/InstallationInstructions/700/758/758-sc1309.pdfCustomer Supporthttps://www.schumacherelectric.com/products/6-2-40-200a-6-12v-fully-automatic-battery-charger-engine-startersome ideas herehttps://www.google.com/search?q=schumacher+sc1309+wiring+diagram..

Question edited for clarity. Question moved from Microwave Ovens. Throw it away, they all sound dangerous and not to modern code. :>D https://hunterfone.diarynote.jp/202109151913477206/ https://www.google.com/search?q=FRANZUS+MODEL+18+instructions ..

you have a short in the unit need a meter to test and check or send out for repair

Question edited for clarity. Question moved from Motorcycles category. Parts suppliers, Parts Diagrams and link to the Maker. https://www.google.com/search?q=motorguide+gator+mount+parts ..

Try setting DUAL BRIGHT to OFF.

Be sure daylight sensor is clear.

Try putting unit into test mode and it should be full ON or full OFF. If not, then likely unit is bad.

need a meter to diagnose and test circuit and wiring ---check breakers also