Baumatic Washing Machines - Recent Questions, Troubleshooting & Support

Yes probably. You didn't give a model # so this part may or may not work. But here it is..... https://www.ebay.com/itm/145011890040?hash=item21c361d778:g:mAkAAOSwJENkJeKD

https://www.glotechrepairs.co.uk/news/baumatic-dishwasher-fault-codes

Baumatic BWM50 manual, pg 50, indicates
e6 error is due to : Water level sensor failure short circuit or circuit break.

Sounds like a transmission issue. Is usually cheaper to replace an appliance than to do a major repair to one.

you probably turned it off before the empty cycle had finished

Drain the machine , drain hose next to drank plug , undo the drain plug and make sure there is nothing stopping the propeller turns using a torch to see with , if all turns and nothing lodged there then it's your pump ps easy job to do and cheap to repair your self , if you need more information get back to me colin evans

Check the Pump filter and pump

not saying this is whats wrong with it i just found this on the internet............hi, you need to empty the filter, ours does the same all too often. The filter is located bottom right of the machine at floor level, which is rather daft for an integrated applicance; we have to remove a whole length of plinth to empty ours. Be warned, a lot of gunge and water will come out so have towels at the ready, especially if you have a laminated floor. Turn the white slot with a a 10p piece......and empty. Not the most pleasant of jobs, but effective. Good luck!