Questions & Answers for: wont gas powered pressure stay

...gas it runs now it wont start un less u put gas in tbi it has a new fuel pump,,was looking at pcm,s today? idle air controll? when you crank the engine do you see fuel spraying from injectors .if you ...

...wont stay running or runs real poor most likely a fuel filter problem. try takeing a rubber mallet {not steel} and pound on the bottom of the gas tank. this will sometimes dislodge whatever is ...

...wont start..fuel pump runs enermidintly My 97 grand prix gtp will not start just turns over changed the fuel filter and relays, i can hear the fuel pump ever once and while. i even pumped the gas to ...

...wont stay running.. pretty sure its the fuel pump...but were is is located yes u are right is the fuel pump most likely, the electric fuel pump is located in the gas tank. Agreed. The fuel pump is ...

...wont stay running I have a Briggs and Stratton 2200 pressure washer with a 4.5 engine and I can't keep it running, you prime it and it runs for a couple seconds and stalls. It stayed running a couple ...

...gas,wont stay on. Fuel filter,plugs,wires,air filter are all good. You can hear the fuel pump working.Has been a great smooth running car so far, Love it but what else is it most likely to be? It is ...

wont stay running unless i rev it high just before i put it in gear, or im accellerating... it idles in park, but instantly dies when i shift into drive unless i give it gas to bring the rpms high, if

wont stay started Starts and shuts off as if it is out of gas this may have a starter relay that would power the fuel pump after started also this will be a fused system check your fuses are their any

...gas pedal all the way down but wont idle. A few days ago the truck got an EGR code, a transmission temperature sensor code, the lightning bolt indicator on the dash lit up, and the heat was ...

...gas.fires up and stays on for about 10-20 minutes, goes out and display reading spark. But wont light up. I turn off power and turn back on and it fires up again with same result. see if voltage to ...