...shutter and keep it open while you inspect focal plain area. Is the shutter fully opened ? If you release again is the shutter opening completely and closing completely ? While the shutter is fully ...
shutter open as long as the release is pushed down. advance one frame and hold down the shutter release while looking at the opening where the lens should be. If the shutter opens you will hear it and
...shutter stuck open). To confirm a stuck shutter, put the camera in any mode other than "Auto", and turn the flash OFF (you don't want to blind yourself for the next step). Next look down the lens and ...
...turning off & closes when I open the camera. But when it is open, the shutter will open a bit making it impossible to take pictures. What should I do or where do I take it for repairs? Tks, ...
...shutter stuck open). To confirm a stuck shutter, put the camera in any mode other than "Auto", and turn the flash OFF (you don't want to blind yourself for the next step). Next look down the lens and ...
Question about N75 with 28-80 lens 35mm Film Camera
...shutter by: 1) open the film door 2) While looking into the camera, press the shutter button. The shutter should open and then close. If the shutter doesn't open and then close, it could be stuck and ...
Question about Program Plus 35mm SLR Camera
...shutter is open. If it is, you can probably see light coming through the lens when looking from the back of the camera. If this is the case, you will need to find out why the shutter is stuck open. ...
...fire the shutter with the camera open/back off, pointed towards a light source, if the shutter opens you will see the light thru the shutter/lens. If no light is seen then the shutter is
Question about Coolpix 8800 Digital Camera
...With the remote, this opens the shutter when you press the button on the remote and keeps it open until you press the button again. This allows you to keep the shutter open for up to 10
...shutter open sensor does not go on. (The shutter does not open.) 1. Check the shutter home position sensor. Is it normal? 2. Check the wiring between the finisher controller PCB and the stack feeding ...
Usually answered in minutes!
159 Questions
136 Questions
123 Questions
113 Questions
100 Questions