...cam and crank sensor still have same code replaced ecm still same code bypased wires still same code. car starts and runs fine up to 2400 rpm I replace both o2 sensors and I am still getting the same ...
cam shaft sensor replaced My car died on the road with no advance warning. Upon using an OBD2 tester, it said the cam shaft sensor was malfunctioning. We replaced the sensor, but the car still will ...
...05 Ex. I do not know where the crank sensor is located. I hope this helps. cam sensor bottom of engine p.s. before you replace part ford has a recall on the cam sensor and might replace free of ...
...cam sensor reads from the magnet every time the engine completes a revolution, what happens is the magnet on the chain will break into smaller piece which makes the sensor harder to read every time ...
...sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be the ...
Question about 2000 Neon
...cam sensor and crank sensor, replace the wiring harness and check the cam shaft magnet! And i have checked the cam shaft sprocket pin to make sure it was not gone " just in case the cam timing ...
Question about 2006 Solstice
replace together, also chk some time double cam motores have to cam sensers. I had a similar problem with my 2007. I followed the code information and a few months later had the issue again. I took it
...is still fastened to the cam gear. the only way to replace this magnet is to replace the cam gear. in which case replace the timing gears and chain at the same time. the timing cover must come
a cam relearn ? Cam sensors should pick up cams you have replaced if they are the ones the manufacture recommends for the vehicle. Any other size cams may not be recognized by the sensor as compatable
Question about 2002 - Liberty
...cam position sensor replaced in 2001 Audi a6 quattro I replaced cam position sensor and there is still no spark to coils what would cause this Throwing any codes? Crank sensor working? The cam and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions