Questions & Answers for: mantis tiller carb settings

mantis tiller 2 cycle seemed as if it was running out of gas pulled the carb and blew it out/ runs much longer but still dies. could the float need adjusting? it has fresh gas. new plug. it runs long ...

Mantis tiller will start and idle, but once you engage it, it stalls. Any ideas? Check the exhaust side of the tiller. There are 3 screws on the muffler cover that need to be removed, then there is a ...

need spark plug gap. and carb setting gap should be about .020 - Carb setting is adjusted while running - lo idle and hi - lo idle adjusted to the lowest RPM before it stalls or starts running rough, ...

Mantis tiller starts but will not stay running starts but will not stay running Carburetor problem. Two stroke engines use oil mixed with gas. Old fuel or setting over the winter will cause varnish ...

...Mantis tiller? When the engine and carb were new, the factory settings were 1 1/4 turns out. As fuel deposits form and things wear, it is normal to need occasional adjustment. If the adjustments need ...

tiller (not a Mantis) that experienced a similar problem. What I did was remove the carberator and completely cleaned it with standard spray carb. cleaner (this is available at ant auto parts store or

mantis fuel tank. This will clean out build up in your carb, etc. Try to start it several times. If unsuccessful after several pulls, let it set for a while. Do this several times until it sounds like

basic carb setting two screws 1-2-or3 turns out basic carb settings are 1 1/2 out as a rule to get started. then adjust after running

...mantis tiller only runs with choke half on .i changed the line set and cleaned carb and plug and still the same. Try fuel with 30% injector cleaner (or 25% auto transmission fluid) Something is ...

...Mantis tiller how many turns should high and low screws be turned out? Turn the carb mixture screw all the way in until it bottoms out and count the turns as you do that, then turn it out the same ...