I have an old (1960's) troy-bilt junior model tiller, and have never had an owner's manual. I noticed the gearbox appears low on oil. What weight oil does the transmission take? these take 90 weight ...
I have an old (1960's) troy-bilt junior model tiller and have never had an owner's manual. I noticed the gearbox appears low on oil. What weight oil does the transmission take? You should use straight
tines continue to work with out touching safety or throttle. they engage as soon as I start the engine. remove H (high) L (low) plastic caps to allow you to further adjust the flow and you will be ...
cannot identify between which is high/low adjusters cleaned carb but mixed up adjusters ! hello mike, the high is longer the low is shorter,
Mantis tiller idle screw adjustment Start out with 1.5 turns on High speed jdet and 1/2 turn on the low speed. Make sure plug is not wet, better yet install a new one. Clean, fresh fuel ...
no ignition to spark plug some have a low oil shut off and if the oil is a little low it will shut the spark off then remove the flywheel cover and unplug the small wire from the coil and check ...
i need a mantis tiller primer bulb or one that will replace it model 7222m just got one at Lowes Hardware. Its a three pack with three different sizes. largest works
...tiller from lowes, it starts but won't run. I have a tiller from lowes, it starts but won't run. check that you have good fuel flow to the carb. if it has a fuel shut off valve make sure ...
compression check engine The compression on my Bronco Tiller 208 cc is 60. It sounds low to me. Is it? What should it be? Thanks! should be 80 and above but should start at 60, but have low power, you
Question about bilt Super Bronco Tiller 208cc
New tiller makes grinding noise when trying to run tillers First time trying to use tiller. Motor running, gear selection in forward with tines running. Loud grinding noise occurs when engaging the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions