Questions & Answers for: adjust slides Music

...For this, the little slide switch has to be on the middle position. Doing this, you have to adjust the monitor volume controls for each

slides to use to to make it play. I plugged it into the "tape in (RCA)" jacks. I need help with the control settings. Thank you Easiest is to use a 1/8 inch stereo to 1/4 inch splitter cable (1/4 mono

AUX sends to thee amplifiers you use for your monitors or your powered monitors whichever you have. Adjust the level using the AUX level controls for each channel to set your minitor mix. Normally use

...removing it you risk bending the tubing out of alignment so that the slide won't fit back in and be adjustable. You also risk distorting the shape of the tubing at either end which again has bad ...

...noise (ground bounce) of different power sources. Leave the speaker slide switch in the Main L/R. Adjust the rotary knobs for Mon1 and MON2 for each channel to proportion each to the monitor

...tube has shorted that caused this. If they are changed the amp will need to have bias checked and adjusted. first solution is false, since the Fender Rumble 60 is a transistor amp, not a tube ...

I HAVE A PMP 3000 WITH A PAIR OF 12" EV PASSIVE SPEAKERS. EVERYTHING SOUNDED GOOD IN THE STORE, BOUGHT IT USED, BUT NOW THAT IT IS AT HOME I CAN'T SEEM TO GET MUCH VOLUME UNLESS I HAVE THE ...

how to adjust truss rod on yamaha f335 guitar F335 acoustic guitar Taken from http://www.learnguitarsetups.com There are a few golden rules when adjusting your truss rod. First, only use the rod to ...

...directly down on the strings. This can take quite a lot of practice to avoid having to make small adjustments after touching down. Start Using Pad More of a noise reduction than noise cancellation, ...