Questions & Answers for: Yamaha adjust slides

replaced throttle cable on pw50 but can't seem to get it adjusted My product wasn't listed so I just picked one! Checked and double checked that it was the correct cable. The slide in the carb isn't ...

...that the clip is attached to at the top of the slide. If you have it in the wrong groove and then adjust you air/idle screw it can make your slide too low or ...

...slides. BALANCE THE CARBS Turn the throttle screw on the LEFT carb one half turn inward. Now start the engine and get it warmed up. With the engine running, remove the RIGHT spark plug wire. Adjust ...

I have a 2003 v star 1100. How do you get the pin out of the clutch lever that is attached to the cable. I purchased a chrome lever and I am trying to change it. HELP............ You need to make the ...

adjust the other slides to the same height as that base carb as close as you can. Measure if possible to get all the carbs as close as possible to each other. you may have to adjust the idle after. If

...adjust the valve with a wrench, only needs about a quarter of a turn, noise should go away for ya. TIMING CHAINS DON'T KNOCK THEY SLAP AGAINST THE HOUSING. IF THIS IS THE CASE, SOME BIKES HAVE AN ...

i have a yamaha pw 80 that starts but stays revd all the way up what screw adjust the idle Check the screw on the side of the carb in the middle, just under the slide and screw it counter clockwise.If

...these carbs. I have removed them from the bike already. write note on where the air screws are adjusted before pulling them out. If you see something you may confuse later take a photo, like ...

my throttle stuck open on my moped Hello wayne...it is probably the cable that is stuck. Try loosening the throttle cable on the handelbar adjustment. Your cable might be too tight & lubricate the

got a yamaha rt 180,can get it to idle,but then wont rev up complete,or can get it to rev up complete,but wont idle then clean carb,even put new carb on,no good Check your jets to make sure nothing is