Questions & Answers for: Suzuki adjust slides

Question about 2001 Grand Vitara

1 Answer

...should be a pulley in that series that in not connected to the A/C or power steering that you can adjust back and forth in order to get the belt to slide on. Then you have to adjust it again to get ...

Ad

Question about 2001 Grand Vitara

1 Answer

...slides. Turn the idle screw on each CARB EXACTLY ONE HALF turn outward and restart the engine. The engine will be probably be idling very fast. Adjust both the idle screws equally from this point to ...

Ad

...In or out? First - I do not know this bike specifically, but with 4-strokes the screw usually adjusts the fuel, not the air in the pilot circuit. Keep in mind this screw only adjusts the

...adjust the synch screw on 1986 gsxr 750 carb and what should the vacuum read? Thanks. Poe I can help with this. On the earliest models they had slide type carburettors. This is to say that the slides ...

Question about 2001 Esteem

1 Answer

how do i remove the alternator how do i get the flywheel off for the belt to remove the top blot? hi from uk 1st disconnect battery earth lead ?? then unplug/disconnect wires from alternator then ...

Question about 2003 RM 250

1 Answer

how do i adjust idle speed There is a screw with a spring around it on the carb on the throat of the throttle slide. Just tighten the screw a little bit. As a matter of fact I would start the bike and

Question about 2004 VL 800 Volusia

0 Answer

Snapped and then replaced the clutch cable. Adjusted it all the way in and then slowly out trying to find the right spot to engage the gears. Have only been able to get 1st, N & 2nd gear. It will ...

Question about 2004 VL 800 Volusia

1 Answer

do I need a brake drum puller to remove the drum from a 2004 suzuki grand vitara? or can I just tap with a hammer to loosen up, then slide off? You can do it either way. If the drums are worn you may ...

Question about 2003 RM 125

1 Answer

Removed carb of Z125 Suzuki. Cleaned it and put it back. Now it over reves the enging. Hi The slide is probably stuck in the carb, it only fits 1 way - with the groove in the slide aligned with the ...

...Suzuki rm250 rear wheel slides back to tighten chain Back of the rear axle nut, then back of the adjuster lock nuts. You then wind the adjuster bolts in equal amounts on each side. When chain has ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...