Washer is not completing the spin/drain cycle. Stops spinning and draining.

SOURCE: Admiral AAV8000AWW washer - clothes are wet after spin cycle...

may be a loose belt or a partial blockage somwhere.

SOURCE: 98702 Washer Drain/Spin Dead.

My Kenmore 98702 washer Fills and agitates as expected but stops at the end of cycle failing to drain or spin

SOURCE: 90 Series Kenmore Washer Not going to spin cycle not draining water

I've had the same problem...you can purchase a replacement lid switch at your local appliance parts store for about $35. Fortunatly, the sales person at the appliance store had diagrams and provided instructions to replace the switch. I was able to finish the job and fix the switch in less than 1 hour. Good Luck.

SOURCE: our hoover ultra care 1300 large load washing machine spin fault

The most common cause of machines stopping mid cycle is not draining. Your machine should have a filter behind the kick plate at the bottom.
If this is not the case please post back for further assistance.

SOURCE: Kenmore front-load washer stops at rinse cycle

When the washer initially fills for the wash, is it only hot water entering the drum? Try switching the water temperature between hot and cold as it fills. If any of them show little or no water getting through, it sounds too easy but check to make sure water supply taps are on, and that the cold/hot fill hoses aren't reversed. Remove the fill hoses and check any of the screen filters for blockage (in the hoses and in the inlet water valve). When the machine stops and waits to fill but all you hear is a hum, it sounds like there is power going to the valve but water is not able to get through it.
Good luck!