I bought a new sony T-300 cam 2008 aug...no probs up to one year.then it start vibrating after taking some photos...........now the same condition.some time it may work properly....then it will again vibrating.I showed this to sony servicing centre.they told that its a ccd problem.it will cost around 10000.any other solution..

There is no other solution. This is a common problem with Sony cameras. They were actually quietly fixing some of them for free for awhile. You should complain loudly.

Sony has discovered that some DSC-T20 and T300 Cyber-shot cameras sold in the United States may experience an issue with abnormal internal vibration and an inability to properly focus and take pictures. For cameras affected by this issue, Sony will provide free repair until July 17, 2011. In certain units, the lens cannot adjust properly due to a mechanical failure in the lens mechanism. When the automatic features of the camera attempt to adjust the lens, the camera body vibrates, preventing it from properly focusing or taking pictures.
if you have any problem regarding this issue post a comment information about the problem.we will glad to assist you

good luck

Not sure about the recall but you have a two year warranty on the bike. Take it back to the dealer and have them replace the radio.
Mike

the valve cover is leaking oil in to the sparkplug area and getting the coil to plug boot wet and causing the spark jump.

simple steps to fix this.. no need to spend any cents

http://crisqv.blogspot.com/2013/10/sony-dsc-t300-vibrating-problem.html

I had a similar problem with my Cyber-shot S600. It just turned off every time I tried to take a photo. I bought a Sony recharger + batteries and it fixed the problem. Camera works fine and I'm impressed with the how long the batteries last between charges.

buy a new disc or if it is u got a bad batch of disc

You likely have a bad optical block. Sony was supplying the optical block as a warranty repair until June of this year, but that warranty has expired.

serial number?

Well, it seems that this is either a manufacturing defect or a defective/sub-standard part being used in the product. It would do Sony well to address this problem immediately so that all of us Sony lovers would continue to believe in their products. If this can be solved via a firmware upgrade then I hope Sony can guide us through it.