Sounds like the coupling between the motor and the transmissionis broken or stripped.
It turned out to be the lid closed sensor on mine. As a temporary solution I had to unsure the left bracket that holds the lid on and pin it down with something.
The washer would fill and then stop and do nothing. Something inside (I have not yet fully investigated) had worn to the point that when the lid was closed it was not quite hitting the button or whatever is inside.
Should not be the cause of a clicking sound but by what your saying the lid switch activator may be bent or the switch be bad. If bent then you can maybe ( after securing to lid again) bend the extension of the lid axle that activates the lid switch slightly toward the lid switch while holding the lid up. The easiest way to see this is remove the case. You can do it 'blind" if you are familiar with the mechanism.
×
429 views
Usually answered in minutes!
×