In the middle of a program, my Lavamat machine stopped working and started to flash the End light 5 times. I turned it off, and when I try to reprogram it, it only flashes 5 times the End light, but nothing happens.
The manual says nothing about the end light flashing 5 times.
Thanks, Rafael.
Check your exit hose spigot, it may be clogged. This is if your filter is all clean(ref manual). There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.
Rate me pl.....if helped. Click on 'thanks for trying' if not helped, your prob will be back for someone else to solve.
(Companies just want you to dump the machine & buy another, its keeps them in business)
could it be anything else as i have same problem but exit hose is clear
×
I had same problem. I can confirm that it is the exit pipe into standpipe blockage/restricted flow. No more 5 flashes for me now. Please add my findings to any other forum you may know of. Cheers.
I happen to have the same problem, have you managed to fix it, How
You will need to change the carbon brushes in the motor. Tip machine 45 deg backwards you might need someone to hold for you and look at motor underneath you will see 2 black carbon brushes remove these and replace if worn then retry machine also make sure the wires to the motor are ok.
1,857 views
Usually answered in minutes!
Hi,
I have the same problem. Checked the filter and exit hose - both not clogged. Any thing else I can try?
×