Gas is on pilot won t light - Frymaster Dean Kitchen Appliances - Others

Rita, Check the attached links,instruction and guides to trouble shoot pilot light, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Gas Heater Pilot Light Troubleshooting
What to Do if Gas Furnace Pilot Light Won Stay Lit DoItYourself com
Furnace Won Ignite Why and What to Do

It sounds like there may be an issue with the gas valve or the thermocouple on your Williams gas wall heater model # 5009622. The fact that the pilot light will not stay lit and the burners came on and went off after cleaning the thermocouple, suggests that there may be a problem with the gas valve or thermocouple. Additionally, the fact that the pilot light went off in the middle of the night, it could also be a sign of a problem with the thermocouple.
Possible causes for this issue include a malfunctioning thermocouple, a faulty gas valve, or a problem with the voltage to the gas valve.
Here are some steps you can try to fix the problem:

1. Check the thermocouple: Make sure that the thermocouple is properly installed and that the wire connections are secure. Also, make sure that the thermocouple is clean and not corroded.
2. Check the gas valve: Make sure that the gas valve is functioning properly and that it is sending gas to the pilot light.
3. Check the voltage: Make sure that the voltage to the gas valve is correct and that the wiring connections are secure.
4. Check for leaks: Make sure that there are no leaks in the gas line.
5. If the problem persists, it's best to contact a professional HVAC technician or the manufacturer for further assistance.

It's important to note that working with gas appliances can be dangerous, if you're not comfortable working with gas appliances, it's best to get it serviced by a professional.

If you dont have gas coming thru while holding down the button, you have one of the following; no gas, main valve off, or a bad gas valve.

light your pilot and take a light to the termopile (right beside your pilot it sticks out to get heat from your pilot. hold lighter for 5 seconds and turn gas on

Would not be a good plan to do this your self gas valve replacement is a gas fitters job

Clean pilot first see if it lights if not you could change thermocouple

The pilot flame must touch (burn) the tip oqef the t-couple to hold the magnet in the gas value open.make sure the pilot orifice (hole) is clear.the pilot pressure (in the tube) is factory set full open & can only be adjusted down (less). Also check the gas **** didn't get closed or turned half way.? Assuming its not the t-couple. If all is good & it still won't stay on. Replace the gas value.!

Hi pilot ligh lit fitted new thermal cupling gas pilot lights hold down switch for over 2 / 3 minutes butgas pilot goes out

Following information is for tank-type gas water heater:
http://waterheatertimer.org/How-to-install-gas-water-heater.html#troubleshoot
http://waterheatertimer.org/pdf/Pilot-light-will-not-stay-lit.pdf
http://waterheatertimer.org/pdf/Attic-Ventilation-and-Pilot-Outage-in-Gas%20Water-Heaters.pdf
http://waterheatertimer.org/images/Water-heater-in-attic-800.jpg

It won't be the pilot light, It will be the gas valve control, if the pilot light actually lights but the burners won't light,, then you need to check the thermocouple , its that little round thing that sits inside the flame of the pilot light, and has (usually) a copper tube that runs back to the actual gas valve, If its gone bad, the signal to the gas valve is lost so the gas never gets released so nothing lights