Timer setting How do I set a newly installed timer.

Here are some steps you can try to get your Magnet (KARLSON) double oven out of demo mode:

Press and hold the "Timer" button for 5 seconds.
If the above step doesn't work, try pressing and holding the "Timer" and "Cook Time" buttons simultaneously for 5 seconds.
If the oven still remains in demo mode, try unplugging it from the power source for 30 seconds and then plugging it back in.

If none of these steps work, please refer to the user manual or contact Magnet's customer support for further assistance

switch the timer off or disconnect
turn the thermostat setting to low
that way it will not work when the solar section is producing enough hot water and when the temperature in the hot water system falls below the thermostat setting it will switch on the power
usable hot water temperature is around 60 degrees c and anything over that will scald the skin within minutes
low thermostat setting is 55 -65 degrees c

The counter reset method depends on the cause of the toner life end message and the condition of the newly installed cartridge.
When a USED toner is installed the reset gear is set to IN USE.
When a NEW toner is installed the reset gear is set to FACTORY SET.

1) Copy following link for programming manual and wiring Tork DTU40 40amp timer.
http://waterheatertimer.org/How-to-wire-Tork-DTU40-timer.html

2) The timer mechanism is old Intermatic/Grasslin/GE discontinued model, and then newly re-minted by Tork in 2012. Timer has 1 year limited warranty against defects in workmanship. This timer is protected from surge by the reset feature, but can burn out in heavy surge event. Non-replaceable Internal rechargeable battery retains programming until timer is reset. Always reset new timer to delete trace memories.

3) This timer can be wired many different ways, and timer automatically detects voltage, so there are no dip switches to set. Timer must be wired before power is turned on. Do not spark-test across terminals.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Insert the Kodak installation CD and set your new connection.

Pay attention to the am and pm markings when setting the timer.

Install the ON tripper pin on the timer dial at the time that you want the controlled device to go ON.

Install the OFF tripper pin on the timer dial at the time that you want the load to go OFF.

Rotate the timer wheel in the direction of the arrows and you should be set.

Gary

The problem is with your windows driver setting you have either not installed all drivers needed by the motherboard or some of the newly installed software is blocking/obstructing the computers shut down database may be because of some automatic update of that software.In that case 1.Insert your windows bootable disk again and load all drivers {only} again by selecting press any key to boot from c.d after the driver loading procedure is complete press enter and then F3 and again enter before the 15 second timer completes and bring your system to the state you were previously in.
2.Run the operating system and then insert your motherboard driver disk in the c.d drive install all drivers needed for the motherboard functioning especially the chipset drivers .
3.Check for any newly installed programs/softwares in the control panel>addor remove programs menu .Remove any newly installed program.
Please take the steps one by one and continue checking in between the problem will be solved in one of the three ways given above

I have a new Citizen watch with World Timer. I want to set the time manually and turn off the world timer. I never want to receive the signal..... The book is no help.

Is this a new problem--ie it was working before? Or is this a newly installed drive?

If it is newly installed then the jumpers are not set correctly. Check that the jumper on the drive is set correctly--Cable select, slave or master as approriate

choose the load size on the timer for what your putting in large small medium etc match the water fill large small med etc select wash rinse temp to you pref add soap bleach fabric softner pull out the knob make sure the lid is closed